User manual MAGNAT MONITOR SUPREME SUB 201A

[. . . ] Please study the instructions and information below carefully before using your new loudspeakers. tHE MAGNAT MONITOR SUPREME SUB 201A AND SUB 301A ACTIVE SUBWOOFERS These subwoofers have been adapted to provide the best visual and acoustic match to the MAGNAT Monitor Supreme range of loudspeakers. However, it goes without saying that they may be combined with other loudspeakers. [. . . ] In this setting, the subwoofer will switch on automatically as soon as a music signal is detected and off again approx. the LED (9) is red in stand-by mode and green when the subwoofer is in operation. The plug should be disconnected from the mains when subwoofer is not used for long periods. Level control (7) This control is used to set the bass volume according to your preferences. Set the bass control of your amplifier into its center (linear) position. Now, play back some music and set the volume control of the amplifier to the desired level. The cross-over frequency should be set to 100 to 150 Hz when the system is used in combination with shelf loudspeakers or 50 to 100 Hz when used with stand loudspeakers. Fuse (1) Only use a fuse with the parameters indicated next to the fuse holder on the rear of the amplifier. iMPORTANT SAFETY NOTICE Never subject the subwoofer to dripping or splashing water. Do not place any flower vases or other filled recipients on top of the subwoofer. The distance between the active subwoofer enclosure and the walls of the room or other objects (e. The aluminium plate and cooling fins of the amplifier at the rear of the active subwoofer serve to cool the built-in amplifier; for this reason, they must also be at least 5 cm away from all objects and must not be covered (e. The bass reflex opening(s) on the active subwoofer must not be covered (e. Please do not touch or connect the mains cable when your hands are damp. Utgångens pluspol är ansluten till motsvarande pluspol vid ingången och att minuspol är kopplad till minuspol. Dessutom bör du se till att avståndet till föremål, sidoväggar och bakväggen uppgår till minst 20 cm, för att förhindra att basåtergivningen dämpas. [. . . ] Should it prove necessary to return the component to the factory, please insure that · The component is packed in original factory packing in good condition · The quality control card has been filled out and enclosed with the component · Your enclose your receipt as proof of purchase. Shipping damages, either readily apparent or concealed (claims for such damages must be lodged immediately with forwarding agent, the railway express office or post office). (You must notify your dealer directly of such defects within three days of purchase. [. . . ]