User manual MAGNAT MA 400

[. . . ] IMPORTANT SAFETY PRECAUTIONS Please read the following information carefully before starting to use the MA 400. INSTRUCTIONS FOR DISPOSAL In accordance with European Directive 2002/96/EC all electrical and electronic appliances must be disposed of separately via local collection points. Please observe the local regulations and do not dispose of your old appliances with normal household waste. Battery disposal Old batteries are hazardous waste and must be disposed of in accordance with current regulations. [. . . ] GB • The transparent protective tab on the underside of the battery compartment must be removed before using the remote control. € If the batteries have run out after prolonged use, please replace them (type CR2025). € To prevent causing damage to the remote control please remove the batteries if the device is not going to be used for a prolonged period. 1 MASTER / 2 AMP Switches the device on when it is in the standby mode. If the LED does not illuminate, actuate the power switch located on the rear of the device. Conversely the device can be switched from power operation to the standby mode. The MASTER button also switches other units in Magnat's M400 series (MCD 450, MT 420) on and off. oPERATIONAL ELEMENTS AND CONNECTIONS – REMOTE CONTROL INITIAL OPERATION • Place the MA 400 on an even surface. Observe the relevant clearance gaps as specified under "Important safety instructions". IMPORTANT: Do not place any objects on top of the device (magazines, CD/record cases, etc. The ventilation slots located on top of the device must be unobstructed at all times!€ Connect your speakers: The stereo speakers (impedance of 4 to 8 ohms) are connected to the rear as follows: 3 INPUT SELECTON These buttons enable direct selection of the individual audio inputs. 4 MENU Launches the menu for adjusting tone and for configuring the inputs. € • • • • • Only use high-quality audio speaker cables with a conductor cross section of min. Loosen the terminal screws one after the other and insert the stripped ends into the holes. You can also use prefabricated cables with 4mm banana plugs or forked fittings. Also observe the operating instructions for the speakers you are using. Connect the supplied mains cable to the rear and then insert the other end into a 230V socket. Actuate the on/off switch on the rear side, the device is now in the standby mode. Now switch on the device using the remote control or with the ON/STBY key on the front. The non-numbered buttons are reserved for operating the Magnat CD player MCD 450 and the Tuner MT 420 and have no function for the MA 400. 9 GB The tone and the inputs' input sensitivity may be comfortably adjusted via a menu. [. . . ] The warranty period is not altered by the fact that we have carried out warranty work. Unauthorized tampering with the equipment will invalidate this warranty. Should it prove necessary to return the component to the factory, please insure that • the component is packed in original factory packing in good condition • the quality control card has been filled out and enclosed with the component • your enclose your receipt as proof of purchase. Excluded from the warranty are: • Illuminates • Valves • Batteries • Wear parts • Shipping damages, either readily apparent or concealed (claims for such damages must be lodged immediately with forwarding agent, the railway express office or post office). [. . . ]