User manual LUMISCOPE MODEL 1134

[. . . ] 10 Correct Measuring Posture . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 11 Applying the Cuff . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 12, 13 Measurement Procedures. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 14 WHO Lighted Indicator . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ] · Operated by 4 "AA" batteries or AC/DC adapter. Note: This unit also offers PC-LINK software. If you order this function, you will receive a separate package including a CD and a connection line with a USB plug. You may order this accessory at our website www. lumiscope. net. Kilopascal: Measures the amount of air pressure that is being inflated into the pre-formed cuff. Memory Average: Shows the average values for an hour, a day, a week, a month and all readings in the Memory Zone. (1~99 readings available) Memory : Holds the memory reads for User 1 through User 4, for up to 99 readings each. Irregular Heartbeat Detector: Indicates when an irregular heartbeat is detected. WHO Light Indicator: Displays six different light signs of Blood Pressure readings against the guidelines set by the World Health Organization. 15) AVG If anyone of these error messages occur while taking your reading, please see the Troubleshooting section. Interference signal around the BPM Incorrect measured result 10 Installing the Batteries Correct Measuring Posture 1. Place your elbow on a table so that the cuff is at the same level as your heart. Relax your entire body, especially the area between your elbow and fingers. If the cuff is not at the same level as your heart or if you can not keep your arm completely still throughout the reading, use a soft object such as a folded towel to support your arm. Avoid leaning back or crossing your legs while the measurement is being taken. Press down on the latch and lift the cover towards you to open the battery compartment. Replace the battery cover by inserting the two hooks at the bottom into the slot, then push on the top area. Note: Please remove batteries when not in use for an extended period of time. Plug the AC/DC adapter (6V 500mA), into the jack located at the bottom of this unit. Use only the adapter included with this unit. Remove batteries when using the AC adapter for an extended period of time. (X) Fig. C Note: 12 To apply the cuff Applying the Cuff Applying the Cuff 13 A. Plug the end of the tubing on the cuff into the connector at the base of the monitor. 2~3 cm (0. 8" ~ 1. 2") Main Artery Left Arm D. To have a secure fit, pull the end of the cuff towards you, wrap it over, then press it for closure. If the Index line falls within the OK range, indicated at the edge of the cuff, this cuff is suitable for your use. If the Index line falls out of the OK range, you may need a cuff with larger circumference. [. . . ] To obtain warranty service on your Lumiscope Blood Pressure Monitor, please contact the Lumiscope Repair Department at 1-800-672-8293 or visit www. lumiscope. net. Upon receipt, Lumiscope will repair or replace, as appropriate, this blood pressure monitor and return it to you. Service of this product by anyone other than the Lumiscope Repair Department voids warranty. In the event that Lumiscope does not abide by the terms of this warranty, the consumer may seek breach of contract remedies in the New York State Federal courts of law. [. . . ]