User manual LUMISCOPE MODEL 1098

[. . . ] · If the Low Battery indicator " " appears on the display, both batteries must be replaced. · "AAA" alkaline batteries or equivalent are suitable for this blood pressure meter. 2 "AAA" type battery Attaching the Wrist Cuff and Posture During Measurement · The blood pressure is measured at the wrist. [. . . ] This causes the "wrist cuff" to rapidly deflate. Subsequent Measurement When a measurement needs to be made again, the time between 2 measurements must be at least 10 minutes. Automatic Power OFF Function If the unit is left on after measurement, an "Automatic Power OFF Function" turns the power off after approximately 3 minutes. To continue with another measurement press the "ON/OFF" switch to turn the unit on. 6 Setting the Clock Enter the setting mode by pressing and holding the MEMORY key for over three seconds. The display will show a blinking year. Then press and release the MEMORY key again, the month will apear and blink to be adjusted, then the date, hour and minute will follow up as you press and release the MEMORY key again. Adjust the clock by pressing the MEMORY key to adjust the values of the month, date, hour, and minute when they are blinking. 7 Memory Recall · You can recall stored data by pressing the "Memory Recall" switch at any time, EXCEPT while taking a measurement. · Up to 42 sets of measurement results can be stored in memory. · When pressing the "Memory Recall" switch, the memory cell number is displayed. The stored measurement results (systolic/diastolic blood pressure) are then displayed. The display will show the memorized pressure and pulse value switching back and forth. · If the "Memory Recall" switch is pressed again, the prior measurements are displayed in the order they were taken. Memory Clear Function You may erase one or all records in the memory. ·Press and release MEMORY key to choose the record that you wish to delete. Remove one or both batteries while the unit is on. 8 Description of Display Marks DISPLAY MARK CONDITION/CAUSE CORRECTIVE ACTION The pressure measured was less than 20 mmHg. Please measure again. The pressure measured was higher than 300mmHg. Please measure again. Pumping error. Please check the cuff and try again. HI or no display The pumping pressure is higher than 300mmHg. Please measure again. Batteries are weak. Replace the batteries. There is a problem with the device. Return to Lumiscope service Department. 9 Specifications Model No. Measuring Principle Measurement Localization Cuff Wrist Circumference Range Measurement Range Accuracy 1098 Full Fuzzy Auto, Oscillometric Method Left Wrist Soft Cuff 5. 4 to 7. 8 in. ±3 mmHg ±5% of reading Systolic blood pressure: 3 digits Diastolic blood pressure: 3 digits Pulse rate: 3 digits Alternatively Pressure Pulse Pressure Pulse Pressure Pulse Rate LCD Indication Marks LCD Switch Inflation Exhaust Rated Voltage Power Source Power Consumption Battery Life Automatic Power-Off Memory Function Dimension Weight Operating Environment Storage Environment CAUTION: View Size Digit Size Temperature Humidity Temperature Humidity Measuring Battery 1. 44(H) x . 904(W)in (36(H) x 22. 6(W)mm) . 44(H) x . 22(W)in (11(H) x 5. 5(W)mm) ON/OFF switch, Memory recall switch Automatic Inflation by Internal Pump Deflation Valve 3 VDC 2 "AAA" Size Batteries 1. 0W Approx. [. . . ] Service of this product by anyone other than Lumiscope Repair Department voids warranty. In the event that Lumiscope does not abide the terms of this warranty the consumer may seek breach of contract remedies in the New York State Federal courts of law. [. . . ]