User manual LUMISCOPE MODEL 1097

[. . . ] You should not be overly worried if you encounter two or three measurements at high levels. It is also influenced by season and temperature. Display Explanation Display: Icons: Systolic Pressure Appears when measurement value is stored in memory or is recalled from memory Appears when batteries should be replaced Diastolic Pressure Shows the pulse rate per minute Pulse Rate No. of Memory Sequence Occurs when a mistake was made during measurement Installing Battery 1. Press down and lift the battery cover in the direction of the arrow to open the battery compartment. [. . . ] Install or replace 4 "AA" sized batteries in the battery compartment according to the indication inside the compartment. Replace the battery cover by clicking in the bottom hooks first, then push in the top end of the battery door. The ON/OFF/START button is pushed and nothing appears on display. Note: Batteries are hazardous waste. Do not dispose together with the household garbage. 4 Applying the Arm Cuff 1. Unwrap the arm cuff, leaving the "Index" end of the cuff through the D-ring of the cuff. 3. The "OK" range indication should be positioned closer to yourself with the rubber tube pointing in the direction of your arm. Position the artery mark ( ) over the main arteries (on the inside of your arm) in the upper arm. Tighten the cuff by pulling the "Index" end of the cuff. 4. Turn your left palm upward and place the edge of the arm cuff at approximately 2 to 3 cm above the inner side of the elbow joint. 5. · Wait about 5 minutes before taking the next pressure measurement. Troubleshooting If any abnormality should arise during use, please check the following points. Symptom No display when the ON/OFF/START button is pressed Check Point Have the batteries run down?EE mark shown on display or the blood pressure value is displayed excessively low (high) Did you talk or move during measurement?Measure it again quietly. Note: If the unit still does not work, return it to your dealer. Under no circumstance should you disassemble the unit and attempt repairs yourself. 7 Cautionary Notes: 1. Avoid dropping or strongly shocking the main unit, and protect it from dust. Clean the blood pressure monitor body and the cuff carefully with a slightly damp, soft cloth. If the unit is stored near freezing, allow it to acclimate at room temperature before use. You should not use any tool to open the device nor should you attempt to adjust anything inside the device. If you have any problems, please contact the store from which you purchased your model 1130 or contact the Lumiscope Repair Department at 1-800-672-8293. [. . . ] You should not use any tool to open the device nor should you attempt to adjust anything inside the device. If you have any problems, please contact the store from which you purchased your model 1130 or contact the Lumiscope Repair Department at 1-800-672-8293. For users diagnosed with common arrhythmia (atrial or ventricular premature beats or atrial fibrillation), diabetes, poor circulation of blood, kidney problems, or for users who have suffered from stroke, the device might not be suitable for use. Do not use on unconscious patients. Specifications: Measurement Method Measurement Range Pressure Sensor Accuracy Inflation Deflation Memory capacity Auto-shut-off Operating Environment Storage Environment Power Source Dimensions Weight Arm circumference K. B. [. . . ]