User manual LISTAESCAN WORKBENCH HANGING CABINET INSTALLATION INSTRUCTIONS

[. . . ] Hanging Cabinet Installation Instructions for Workbenches and Height-RightTM Workbenches Instructions for installing the hanging drawer to a HeightRightTM workbench Hardware included: · 2 ­ ¼-20 x 3" hex head bolts (A111997) · 4 ­¼ -20 x ½" phillips head screw (A100318) · 6 ­ ¼" washers (A108682) · 2 ­ galvanized channel brackets x (A109586) · 2 ­ rear brackets y · 1 ­ front spacer bracket z Tools required: · ratchet set, with extension · Screwdriver, phillips and flat head · Gloves · Before starting, raise the Height-Right workbench to the highest setting to improve access to underneath of workbench. [. . . ] · Lifting back of housing first, place rear brackets over the bottom flange of rear channel. (See Figure 2) · Lift front of housing and place one channel bracket into the front channel and turn bracket 90º. · Using a flat head screwdriver, indent tabs on rear brackets so they go over the bottom channel flange. This is important since it prevents the housing from moving when drawer is opened. channel bracketx Front spacer bracket z Figure 2 Rear Height Right channel (under worksurface) REAR Rear hanging cabinet mouting bracket y SIDE PROFILE (REAR OF HANGING CABINET) To install hanging drawer to an industrial or technical workbench · · · · · If possible, turn workbench top upside down to install drawer. If attaching hanging cabinet to a top provided by Lista, drill a 5. 1mm pilot hole. Otherwise, drill a pilot hole according to top provider's specifications. Using lag screws provided with your workbench top, secure to bottom of worksurface. [. . . ] All Rights Reserved ­ ISO9001 Certified J:\ASSYINST\MD030A3\HC_REV1. DOC SIDE PROFILE (FRONT OF HANGING CABINET) 03/01/02 [. . . ]