User manual LISTAESCAN STORAGE WALL ROLLER SHELF INSTALLATION INSTRUCTIONS

[. . . ] Storage Wall® Roller Shelves Assembly Instructions and Layout Guide ! CAUTION ALWAYS SECURELY ANCHOR STORAGE WALL SYSTEMS TO THE FLOOR OR A SOLID OR REINFORCED WALL WHEN USING ROLLER SHELVES. FOLLOW LOCAL REGULATIONS AND BUILDING CODES TO DETERMINE THE PROPER METHOD OF ANCHORING. [. . . ] · Continue installing the roller shelf tracks, leaving at least four open slots in the Vertical Side Frame between each track. · Once placement of all tracks is completed, insert the white plastic shelf retainer slip (#15) to secure tracks · Refer to Figure 1. Using four ¼-20 x 5/8" hex head bolts (#8), install the back panel (#3). If access to the rear of the storage wall is not available, install the back panel backwards. · CAUTION: Units must be level in all directions and securely anchored to the floor according to local regulations and building codes. Fixed end goes into the left track (#1), spring loaded end goes into right track (#2). Depress spring loaded end with a medium flat head screw driver to slide shaft into the hole in the right shelf track. · Install left gate bracket (#5) by sliding it into the left track (#1) and align with the angled gate slot. Secure using one ¼-20 x 5/8" head head bolt · Grease or lubricate both ends of the Gate Pivot Rods (#4). · Place a flat washer (#9) on the left pivot rod of the gate and insert rod into the left gate bracket. Place a flat washer (#9) over the right pivot rod of the gate and insert into the right gate bracket. Install the right gate bracket (#6) by sliding it into the right shelf track (#2). [. . . ] 5") open slots between bottom panel & shelf track Component and Hardware List ITEM 1 2 3 4 5 6 7 DESCRIPTION QTY Shelf Track - left 1 Shelf Track - right 1 Backstop 1 Front gate* 1 Gate bracket ­ left 1 Gate bracket ­ right 1 Conveyor Rollers ­ 21-3/4" deep 7 ­ 27-3/4" deep 9 8 Hex head bolts ­ ¼-20 x 5/8 6 9 3/8" flat washer 2 10 Gate handle (aluminum)* 1 11 Gate handle label 1 12 Gate handle label plastic cover 1 13 End cap ­ left* 1 14 End cap ­ right* 1 15 Track retainer clip 2 * The front gate, including the aluminum handle and both end caps, will ship pre-assembled. Figure 3 ­ Install Conveyor Rollers Figure 4 ­ Completed Roller Shelf Layout Guide for Roller Shelves · · · · · · Bottom Shelf must be a minimum of 5" (125 mm) or 5 notches from bottom universal panel. Roller Shelves adjust in 1" (25 mm) increments Minimum clearance needed for each shelf is 4" (100 mm) Roller height: 2" (50 mm) Total usable height of 1450 unit Storage Wall section: 53" (1350 mm) Total usable height for 2000 unit Storage Wall section: 75" (1900 mm) Suggested Layout for a four shelf section GATE HEIGHT 4" [100mm] 106 Lowland St Holliston, MA 01746 E-mail: sales @ listaintl. com http://www. listaintl. com/ For Technical Asstance, please call 800-423-1350 MD007A3 Rev 1, 11/2001 ©2001 Lista International Corp. [. . . ]