User manual LENCO WR-34 PLL

[. . . ] WR-34 PLL RECEIVER PLL SYNTHESIZED STEREO WORLD RECEIVER Operating Manual NW / SW / FM ST. PLL SYNTHESIZED STEREO WORLD RECEIVER ALARM FM MW SW SLEEP LOCK 106. 5 5 M2 M3 MEMO CH +5 MHz 5 M1 M4 M5 MANUAL / AUTO SCAN UP HOUR DOWN MIN ON / OFF Please read this manual before operation Installing batteries (not included) 1. [. . . ] During the sleep time displayed period, the sleep time can be changed by pressing the [SLEEP] button. Each push of the SLEEP button will change the SLEEP time according to the following flow: the SLEEP mode is set. 3. Press [SLEEP] button to select the period of time (90, 80, 70, 60, 50, 40, 30, 20 or 10 minutes), Each additional press of the [SLEEP] button will reduce the remaining sleep time in 10-minute increments, to the nearest 10 minutes. Example: If there are 90 minutes remaining in sleep, pressing the button once will reduce the sleep time to 80 minutes, twice will reduce it to 70 minutes, etc. 4. 6. Wait for about 5 seconds and the sleep function will be activated automatically. When listening to the Radio, this function turns the Radio off automatically after a predetermined time To eliminate the SLEEP mode press the [SLEEP] button until "SLEEP" symbol disappears or press [ON/OFF] button. Press the [AL ON/OFF] button, the digit hours and minutes with "ALARM" symbol is blinking, will be displayed on the LCD for 5 seconds. While the time display is blinking, press and hold down the [DOWN/UP] button or intermittently until the desired wake-up time is reached. The "ALARM" symbol will appear on the display Indicating the alarm is set, the buzzer will sound automatically when a predetermined time. To permanently cancel the alarm, press the [AL ON/OFF] button, the "ALARM" symbol will be removed from the Display. Radio operation Switch on your radio by pressing the [ON/OFF] button. The radio will be turned on at the last preset radio station and volume. A. Scan Tuning: The unit is equipped with an Auto-Search function and can automatically search for the next clear channel. Press and hold the [DOWN/UP] button for 2 seconds and automatically the value of the frequency will Keep increasing or decreasing until a clear channel is found. [. . . ] To release the lock switch simply move the [LOCK] switch to the off position, the "KEY" symbol will be Removed from the display. This document was created with Win2PDF available at http://www. daneprairie. com. The unregistered version of Win2PDF is for evaluation or non-commercial use only. [. . . ]