User manual LENCO SP-500

[. . . ] Do not place naked flames, such as lighted candles on or near the product. ⷠDo not place objects filled with liquids, such as vases on or near the product. ⷠDo not install this product on top of other electrical equipment or on uneven surfaces. [. . . ] ⷠAllow suitable distances around the product for sufficient ventilation. ⷠVentilation should not be impeded by covering ventilation openings with items such as newspapers, table cloths, curtains and the like. Damage caused by using this product in an unstable position or by failure to follow any other warning or precaution contained within this user manual will not be covered by warranty. lenco suggests retaining the packaging in case for future transport of the product. SPEAKER PLACEMENT Lenco recommends placing the speakers as follow: Have an uninterrupted line of sight to the speakers. Moving speakers closer to the walls and corners increases the bass but also makes it more uneven. Try 45 to 120cm to start with and avoid making the distance to the sidewalls the same as the wall behind the speakers. Best stereo is usually achieved with the speakers and the listener positioned at the points of an equilateral triangle as follow and the speakers pointing to a spot just in front of the listening position. Left ­ right symmetry helps, so for example try to avoid heavy curtains on one side only. CONNECTING THE SPEAKER Use cable of equal length to both speakers and keep them as short as possible. The excess cable should be folded concertina fashion into a bundle and tied for neatness. Run leads away from mains leads and obvious sources of radio frequency energy such as mobile cordless telephones. In general, the thicker the speaker cable, the better use cable where the two conductors are easily distinguished. Make certain there are no stray strands of wire bridging the (+) and (-) terminals. [. . . ] CHOICE OF AMPLIFIER A low powered amplifier will give satisfactory results only at low volume settings. To obtain the best performance from your speakers, try to use an amplifier rated near to or slightly in excess of the power rating of the loudspeakers. <<< Design and specifications are subject to change without notice >>> If at any time in the future you should need to dispose of this product please note that: Waste electrical products should not be disposed of with household waste. [. . . ]