User manual LENCO RC-8-2

[. . . ] P. 1 (1) IR (Infra-red) Transmission IR is being "sent" or "received". (3) POWER key The POWER key controls the same function as on your original remote control. (4) Number keys The number (1-9, 0, 11, 12) keys provide functions just like your original remote control. (5) -/-- key If your original remote uses one/two digit input switching (-/--), this Function can be obtained by pressing the -/-- key. [. . . ] The LCD shown as SUCCESS and the RC-8-2 is now ready to operate your TV. In any cases if you need to leave the quick/manual search, just press the [ESC] key to exit, the LCD will be shown as EXIT and back to normal operation mode. 11. To program other equipment, repeats the Steps 1-9 for your VCR, SAT, AUD and or your second TV or VCR or SAT. Press the [SET] key to for 2 seconds Press & release the [CH+] Press the [SET] key once Press the [DEVICE] key to select a desired mode Press the [SET] key to save the working code P. 5 SETTING UP BY LEARNING The RC-8-2 comes with a complete library of pre-programmed codes. After you have set up the RC-8-2 for your device, you may find that there are one or more keys that you had on the original remote control, which do not have a place on the RC-8-2 keypad. The RC-8-2 offers a special learning feature that allows you to copy almost any function from your original remote control onto the keypad of the RC-8-2. Before you start : ?Make sure your original remote control is working correctly. ?Make sure neither your RC-8-2, nor your original remote control is pointing at your device. To Learning (direct) : For example: To copy the "PIP" function from your original TV remote control onto the "I I" key of your RC-8-2. Make sure the ends which you normally point at your device are facing each other. Point the original remote to the front center head of the RC-8-2 (see picture below). Press the [SET] key to for 2 seconds and the LCD will be shown CODE SETUP. Press & release the [CH+] key for two (2) times to view the LEARN MODE page. Press the [Device] key to select a desired mode (TV, VCR, SAT or AUD, etc. . ). Press the "I I" key on the RC-8-2 remote where you want to place the learned function, the LCD shown as TV LEARNING. Press & hold the key that you want to copy (Example: PIP key on your original remote control). After learning is OK, the LCD shown as SUCEESS for 3 seconds then shown as TV LEARN KEY. If you want to copy other functions within the same mode, simply repeat steps 6 and 7 pressing the next key you want to copy by learning. 9. If you want to copy another function in a different mode, simply continue step 4 followed by steps 5, 6 and 7. In step 6, by pressing the [SET] key or Device mode key, you will exit the learning mode and back to normal operation of RC-8-2. Press the [CH+] key for two (2) times to the page of delete all keys and now the LCD shown as TV DELETE ALL. Press the [Device] key to select a desired mode (TV, VCR, SAT or AUD, etc. . . ). [. . . ] Press the [SET] key to for 2 seconds and the LCD will be shown CODE SETUP. Press & release the [CH+] key for seven (7) times to view the MARCO SET page. Press the [SET] key to enter MAC1 operation and the LCD shown as MAC1 KEY-01, press the key in the following sequence: 6. To store the MAC1, press the [SET] key to confirm and LCD shown as SUCCESS and back to normal operation, or press the [MAC1] or [MAC2] key for escape and the selected macro keys will not be stored. [. . . ]