User manual LENCO PA-80

[. . . ] Make sure all input devices such as microphones, CD players, mp3 players, and linked amplifiers/ PAs are turned off and volume settings are set at "zero" 7. Connect the stereo outputs to the power amplifier(s), tape decks, and/or audio sources. [. . . ] REPEAT BUTTON: Use this button to repeat one track or all the track of the CD. PITCH BEND - BUTTON: The pitch will drop while the - button is pressed and return to the original pitch when it is released. PITCH BEND + BUTTON: The pitch will automatically rise when the + button is pressed and return to the original pitch when it is released. PITCH BUTTON: If you this button, the adjustement of the pitch potentiometer is available. FOLDER/TRACK SEARCH: Allows you to navigate through folders or tracks similarly in either USB or CD mode. When navigating a standard CD turn the rotary to the right to advance the selection or turn the rotary to the left to decrease the selection. CONTROL PANEL: 22 23 24 25 22. MICROPHONE 1 BALANCED INPUT WITH GAIN CONTROL(1/4" AND XLR):This jack can either take a 1/4" balanced or a XLR balanced cable. INSTRUMENT/MICROPHONE 2 INPUT WITH GAIN CONTROL(1/4"): This mono input accepts a 1/4" input such as a microphone, guitar, or other musical instrument. USB/SD/AUXULIARY INPUT WITH GAIN CONTROL (STEREORCA): This knob controls the level of the USB/SD and the RCA input. This stereo RCA input can be used to connect a CD, M P 3 , o r o t h e r a u d i o s o u r c e . To c o n n e c t t o a p o r t a b l e d e v i c e w i t h a 1 / 8 " h e a d p h o n e j a c k , y o u need a standard (1/8" to RCA) adapter which is NOT included. MASTER VOLUME CONTROL: This knob controls the master volume of the. POWER PANEL: LINE INPUT POWER SUPPLY ~115/230V, 60/50Hz POWER CONSUMPTION 70 WATTS FUSE T2AL 250V 26 28 27 29 30 31 26. [. . . ] Uninstalled all fixed screw back, remove retaining plate, please open negative (-), then open court since the positive (+), remove the battery replacement court since, replacement battery, please confirm battery position installed correctly, put fixed plate and tighten the screw securing plate fixation plate, until the motionless, but don't screw it too tight. You should seek dealer or local organs of qualified opinion processing waste storage battery. SPECIFICATIONS Input Voltage: AC 100-120V/ 60Hz 220-240V/ 50Hz POWER CONSUMPTION:70 WATTS Frequency Response: 70Hz~ 50kHz +/- 3dB Produce dimensions:350x428. 5x245. 5mm(wxhxd) Bottom pole mount specifications: Standard Pole Mount found at professional audio retailer: Depth 80mm (3. 15") Diameter 35. 5mm (1. 40") Time required to fully charge the: under 4 hours Battery life: Over 12 hours* at full volume of full volume of the when fully charged. [. . . ]