User manual LENCO MDV-6

[. . . ] The distance of remote control should not exceed 7 meters, or else, it will be invalid. If the sensor or remote control emitter is stuck with foreign matters, it may result in the malfunction in signal reception or not at all. The remote control function may be affected under the strong interference signals, such as power supply and other strong high-frequency signals. REMARK: Remote Control Battery Type: Size: AAA Standard Voltage: 1. 5V -6- CONNECTION WITH TV 1. [. . . ] PC computer) with this unit, then press the Audio button on the front panel or remote control to enter Audio status to enjoy the outer audio source. Press the FM button on the remote control or front panel to select tuner. Press the Play/Enter button or DVD button on the front panel to select DVD mode. You can use the direction buttons to move the cursor to the desired title menu, press Play/Enter button to play it. If the title menu is represented by numbers, then press the number buttons to select directly. -14- BASIC OPERATION MPEG4JPEG PICTURE DISC PLAYING FUNCTION 1). Place the MPEG4/JPEG disc into the deck, this unit will begin to read, the main directory will be displayed on the TV screen. Directory Area Play File Selection Area 2). Press the direction button to move the cursor to the corresponding directory, press Play/Enter button to enter the next layer, and so on, until the desired picture is found for play. During play, number buttons or button can be used to select pictures. JPEG pictures may distort at the edge to some TV sets, this is not a unit defect. This unit can play the digital photo discs with extension name . JPEG, and also support the picture that made by Adobe Photoshop. If you want to repeat playing some pictures, pressing the Repeat button is OK. After go into the subdirectory in playing MPEG4 disc, also you can do the operation such as fast backward, fast forward, pause. Enter FM Function In the turn-on or play status, press the FM button on the remote control, enter FM status. Select Bands 1) 2) directly input frequency: press the T/F button on the remote control, input the frequency that you want directly. Select band by pressing Tune- or Tune+ button: under some frequency, press the button, the frequency will be up or down on the step. The step of FM is 0. 05 MHz . If keep to press these buttons, the device will switch to search bands from up or down automatically. 3) Select band by pressing number buttons: you may select the bands that have been saved by pressing the number buttons. For example: press 10+ button twice, 5 button once, you may select the 25th band. 4) Automatically search bands: press the Search button, this unit will start to search bands from the lowest part to highest part automatically. Save Bands Press the Save button, that means saving the current frequency of band. For example: If you want to save 99. 3 MHz in 28th, please press 10+ button twice, 8 button once, then press T/F button to input 993, then press Save button to save this frequency. Soundtrack Selection Press MO/ST button on the front panel, you may select Mono and Stereo soundtrack output in FM status. Exit FM Status Press the Play/Enter button to exit FM status and enter the disc playing. [. . . ] (2) RF Remod: no compression for the input signal, higher volume and applicable to day. Dynamic Range When the output mode is Line Output, this unit will automatically adjust the linear compression ratio to acquire different compression effect of signals. When the option Full is chosen, the peak-peak value of audio signal will be the minimum; when OFF is chosen, it will be the maximum. Dual Mono To set the output mode for left and right audio signal, Available options: Stereo, Mono L, Mono R and Mix Mono. The pictures above will appear on the TV screen in case of menu setup. [. . . ]