User manual LENCO MC-140

[. . . ] The incorrect use of batteries can cause electrolyte leakage and will corrode the compartment or cause the batteries to burst. The ventilation should not be impeded by covering the ventilation openings with items, such as newspapers, table-cloths, curtains, etc; No naked flame sources, such as lighted candles, should be placed on the apparatus; Do not expose the apparatus to dripping or splashing and do not place objects with liquids, such as vases, on the apparatus; Do not place the product in closed bookcases or racks without proper ventilation. Where the mains plug or an appliance coupler is used as the disconnect device, the disconnect device shall remain readily operable. CLASS 1 Laser product. 1 LOCATION OF CONTROLS 2 NAMES OF CONTROLS 1. [. . . ] The display will show CD READ , then the total number of tracks, album (if a MP3 disc contains several albums) and STOP will appear on the display after several seconds. To remove the CD, press OPEN to open the CD compartment lid, the display will show OPEN . To ensure a good system performance; you need to wait until the disc tray completely reads the disc before proceeding. If no disc loaded into the compartment, or the disc is unreadable, the display will show NO DISC . The total number of tracks and playing time (only Audio CDs) will appear in the display (MP3 shows number or folders and tracks). SELECTING A DESIRED TRACK/PASSAGE To select a desired track CD: Press CD SKIP BACK/FORWARD & RADIO TUNING UP/DOWN button repeatedly in stop mode or during playing until the desired track appears on the display. MP3: Press the MEMORY UP / ALBUM + button repeatedly in stop mode or during playing to select desired album. Then press CD SKIP BACK/FORWARD & RADIO TUNING UP/DOWN button to select desired track. To search for a particular passage during playback (track scanning at high speed) Press and hold CD SKIP BACK/FORWARD & RADIO TUNING UP/DOWN button to scan the current playing track at high speed until desired point (passage), then release the button for normal playback mode. Playback will start again from this point. 5 PROGRAM TRACKS Program tracks of disc are possible when playback is stopped. In stop mode, press MEMORY button to enter program setting, the display will show 00 P -- 01. 2 Press the CD SKIP BACK/FORWARD & RADIO TUNING UP/DOWN button to select the first desired track to be programmed. 4 Repeat steps 2 & 3 to store other desired tracks until all tracks are programmed. 5 Press the PLAY/PAUSE button to start the playback from the first programmed track. Note: For MP3 disc program setting please follow the instruction described at PROGRAM TRACKS ON USB (MP3) To Erase the Memory (Program) You can clear the program by two ways: 1. Open the CD compartment lid, program will be erased. REPEAT You can play one track or all tracks on the disc repeatedly. Press REPEAT button once in playing mode, " REPEAT " appears in upper left corner of the display. The current track will be played over and over again until you press the STOP button. To cancel the repeat playback, press and keep pressing the REPEAT button until REPEAT goes off on the display. Press REPEAT button twice in playing mode, "REPEAT ALL" shows in the display, all tracks on the disc will be played over and over again until you press the STOP button. To cancel the repeat playback, press and keep pressing button REPEAT until REPEAT ALL goes off on the display. [. . . ] Notes on handling discs Removing the disc from its storage case and loading it. Do not expose discs to direct sunlight or high temperatures, high humidity or dusty places. 8 4. Cleaning a disc Should the disc become soiled, wipe off dust, dirt and fingerprints with a soft cloth. The disc should be cleaned from the center to the edge. Never use benzene, thinners, record cleaner fluid or anti-static spray. [. . . ]