User manual LENCO L-80 USB

[. . . ] Use only with a cart, stand, tripod, bracket, or table specified by the manufacturer, or sold with the apparatus. When a cart is used, use caution when moving the cart/apparatus combination to avoid injury from tip-over. [. . . ] ANTI-SKATE KNOB When a record is playing, a force is generated drawing the stylus towards the center of the record. This control compensates for that force and needs to be set to the same value as the counterweight pressure ring. PHONO/LINE OUTPUT Connect the turntable to any phono or line level input, using the supplied cinch/cinch cable. When playing a 45rpm record with a large center hole; place the 45rpm adapter on the center spindle. Set the cueing lever to the down position, the tone arm will descend slowly onto. Adjust the pitch to a desirable speed, move the pitch control slider up or down to adjust the speed. When play is finished, raise the cueing lever, move the tone arm to the arm-rest and secure the tone arm with the arm clamp. SET-UP ASSEMBLY: Before you begin assembly please be sure all parts and accessories have arrived intact. please use the Check list below to identify and order parts and accessories. * Instruction manual * RCA cable * Slipmat * Platter * 45 rpm adaptor * Headshell * AC cord * Counterweight Note: * Do not connect the AC power plug before assembly has been completed. * Before turning the power on, make sure once again all the connections and power voltage settings are correct. Always turn off the power when connecting or disconnecting * Read this manual carefully before using the unit. * Attach a stylus cartridge to the headshell before assembling the turntable unit. 1 Removing from carton: Carefully remove the main unit with the packing material intact from the box. [. . . ] Output terminals Amplifier(Receiver) L (White) L CH R (Red) R CH You can also use a line input by setting the phono / line switch at the rear of the turntable to line. If at any time in the future you should need to dispose of this product please note that: Waste electrical products should not be disposed of with household waste. [. . . ]