User manual LENCO IPOD-BALL

[. . . ] No naked flame sources, such as lighted candles, should be placed on the apparatus. Power Source The unit should be connected to a power supply only of the type described in the operating instructions or as marked on the appliance. Where the AC/DC Adaptor is used as the disconnect device, the disconnect device shall remain readily operable. Power Cord Protection Power supply cords should be routed so that they are not likely to be walked on or pinched by items placed upon or against them. [. . . ] POWER button ----- To turn the unit on and off ; select iPod or AUX-IN mode 4. Accessories - iTunes USB cable x 1 - Auxiliary audio line in cable with 3. 5mm stereo plugs ; Length = 1 Meter x 1 - Auxiliary audio line in cable with 3. 5 Meter x 1 - iPod docking station cover x 1 - AC / DC power adaptor x 1 This model adopts different iPod models. If the docking port will not be used for an extended period of time, it is recommended to cover the docking port by using the "Dock Cover " insert (included). Select a suitable adaptor for your iPod (the one with your iPod at the time of purchase) and insert it into the docking area. Your iPod can now be inserted into the docking port by placing the connector on the bottom of the iPod onto connector in the docking bay. Caution : Please be careful when seating the iPod into the docking to avoid damaging the 30-pin connector on the iPod or in the docking system. When the unit is at power off mode, the Red colour power status indicator is on. Press the POWER (STANDBY) button once to turn on the unit and the power status indicator turns Blue. Note : Press the POWER button will toggle between iPod and AUX-IN mode, the Blue power indicator on. - When a song playback, press and hold the / button to perform high speed search forward / backward. From the remote control, it can implement following operation as well: - To access iPod menu, press the MENU button. - You may press the navigation buttons ( Up / Down / Left / Right / Enter buttons) as from you iPod to highlight and select desired items. To turn off the unit, press and hold the POWER (STANDBY) button until the power status indicator turns Red. When the unit is in standby mode and the iPod is connected the unit will automatically charge the iPod's battery. The unit provides an iTunes connector located at rear of the unit and let you implement the iTunes function without unplug the iPod from the docking station. Treble setting : - Press the TREBLE button once entering Treble setting mode, the status indicator blinks between Pink and Blue light. [. . . ] Note: (1) If you connected the Line Out Jack of your external device then you only need to adjust the volume control of this unit. If you connected the Headphone Jack of your external device then you may need to adjust both the volume control of your external device and the volume control of this unit to find the most desirable volume setting. (2) Press and hold the POWER button turning off the unit (the power status indicator turns red) when you finish listening. Don't forget to switch off power of your external device as well. [. . . ]