User manual LENCO IPD-4000

[. . . ] No naked flame sources, such as lighted candles, should be placed on the apparatus. Before turning `On' the power, make certain that power cord is properly installed. No objects filled with liquids, such as vases, shall be placed on the apparatus. [. . . ] This model is equipped with non-skid rubber 'feet' to prevent the product from moving when you operate the controls. These 'feet' are made from non-migrating rubber material specially formulated to avoid leaving any marks or stains on your furniture. However certain types of oil based furniture polishes, wood preservatives, or cleaning sprays may cause the rubber 'feet' to soften, and leave marks or a rubber residue on the furniture. To prevent any damage to your furniture we strongly recommend that you purchase small self-adhesive felt pads, available at hardware stores and home improvement centers everywhere, and apply these pads to the bottom of the rubber 'feet' before you place the product on fine wooden furniture. To extend the life of the original battery we have inserted a small clear plastic spacer tab between the lithium battery and the battery terminal. You must remove this battery spacer tab before you can use the remote control. When the operation of the remote control becomes intermittent or unsatisfactory, replace the original battery with a new 3-volt lithium battery. Notes: Use a well-known brand of cell battery for longest life and best performance. Make sure the AC power cord from this unit is properly connected to a 230V 50Hz household AC power outlet. Make sure that the minimum distance around the whole unit for sufficient ventilation is 10cm. 2) Press PREV button on the remote control or iPod unit to go back to the previous song. Press UP/ DOWN button on the remote control to select up or down of the iPod menu; then press the ENTER button to enter selected menu. In order to prevent unwanted distortion during iPod® playback, it is recommended that you set the EQ in your iPod® to the "Off" position. Go to the Main Menu in your iPod® and then select the Settings Menu, select the EQ Setting, and make sure that the EQ function is set to "Off". [. . . ] After turning `On' the unit, you will need to reset the settings again. Do not use any wax, polish sprays, or abrasive cleaners on the cabinet. Never allow any water or other liquids to get inside the unit while cleaning. [. . . ]