User manual LENCO DVL-2253 BLACK

[. . . ] If you notice smoke, an excessive build up of heat or any other unexpected phenomena, you should disconnect the plug from the mains power socket immediately. The mains plug or appliance coupler is used as the disconnect device, the disconnect device shall remain readily operarble. This set should only be connected to a mains power supply which matches that stated on the label on the rear of the TV ­ do not attempt to connect it to any other type of supply. The socket ­ outlet must be installed near the equipment and easily accessible. [. . . ] SCART: Connect them to the SCART video output terminal of DVD. (used in component source) Headphone: Connect it to your headphone or other audio equipment. R/L in: Connect them to the audio output terminal of DVD. (shared with YPbPr) VIDEO: Connect it to video output terminal of DVD. YPbPr: Connect them to the YPbPr video output terminal of DVD. (used in component source) Caution: Before connecting external devices: Makes sure to disconnect the appliances from the power supply in order to avoid any potential damage from occurring. Make sure that the connectors are properly and correctly attached before connecting the appliances to the power supply. 8 Connecting external devices (continued) PC connection As PCs are sometimes still supplied with a `conventional' CRT monitor, you may need to adjust the display settings of your PCs graphics card, otherwise the pictures may not appear correctly. Switch on your PC (still with your original monitor connected) no w select the screen resolution, and select 60Hz refresh rate. Switch off your PC, then connec t it to your TV while both appliances are still switched off. VGA, HDMI PC Connection Use a PC-VGA cable (not supplied) to connect the TV to your PC. You can also use an HDMI cable to connect to your PC (if your PC Graphic card supports HDMI). When the HDMI cable is used, the PC audio cable is no longer required. If you use the HDMI to DVI cable, you will need to use the PC audio cable. Contact your Pay Per View TV service provider to get more information about the modules and subscriptions. NOTE: Conditional Access Module and Smart Cards are sold separately. WARNING!SWITCH OFF YOUR TV BEFORE ANY MODULE IS INSERTED INTO THE COMMON INTERFACE SLOT, THEN ADD THE SMART CARD TO THE CAM. 1. If the CAM is detected the TV will display the following message on the screen. "Common Interface Module inserted" wait for a few moments until the card is activated. When the module is removed, the following message will appear on the screen. "Common Interface module removed". 12 Auto installation setup Power On / Off the LCD TV 1. -To turn off the TV Press POWER button on the TV or remote control. When you initially turn on the LCD TV you will see the first time installation menu as below: Ensure that the aerial is plugged in to the TV, Make sure your Remote is in TV mode (by pressing INPUT button), switch on the TV by pressing POWER. You will see the first time installation menu. START SEARCH Source Menu You can select the input source menu by pressing the Source button on the remote control or the INPUT button on the LCD TV. INPUT SOURCE ATV DTV HDMI SCART YPBPR AV VGA DVD 13 Bas c Use Menu Settings 1. Press the EXIT button to exit the Menu. CHANNEL MENU Allows you to search channels and set up a variety of channel options. (Select DTV source for example) (Select DTV source for example) SETTING MENU: Allows you to customize the sound options and effects. (Select DTV source for example) Allows you to setup a variety of setup options. (Select DTV source for example) FUNCTION MENU: Allows you to set up a variety of lock/time and setup options. [. . . ] Lock the buttons on the TV set, you could not operate the TV by the buttons on the TV set. Press button to enter the First Time Installation menu. 21 Menu Settings (continued) Use the and buttons to select the PC SETUP menu (as the picture above), press button to enter the menu. The PC SETUP menu includes the following options : H-Position V-Position Clock Phase Auto Adjust Adjust the transverse position of the screen. Adjust the pixel clock frequency, until the image size is maximized for the screen. [. . . ]