User manual LENCO DVD-431

[. . . ] If a disc with rough edges is used, the player may not be able to play the disc. Therefore, remove the rough edges in advance by using a ball point pen or pencil as shown on the right. To remove the rough edges, press the side of the pen or pencil against the inside and outside edges of the disc. Rough spots on outside edge Rough spots on inside edge When in stop mode, press the button, the play can be resumed from the stop point. [. . . ] Each time the button is pressed, the speed of rapid forward/reverse changes according to the disc as follows. Slow Motion Playback (For DVD Only) Press the / button on the remote control during play. Each time the button is pressed, the speed of slow forward/reverse changes according to the disc as follows. In slow motion state, press OK or on the remote control or on the front panel to recover normal playback. Skipping Track Press the / buttons on the remote control or on the front panel during playback. DVD VIDEO MENU PLAY When playing a DVD disc in the DVD player: 1) The disc will be played automatically and stop at menu picture. MENU FUNCTION Press the MENU button on the remote control during DVD mode wll return to the menu stored in the current disc. AV OUTPUT There is a AV OUTPUT TYPE Switch on the rear case, when switch it to A, AUDIO/VIDEO OUTPUT (1) /(2) are controlled by MODE button on the front panel or on the remote control, and the output signal can be changed among DVD, AV IN 1 (on the front panel ) and AV IN 2 (on the rear case). When you switch it to B, AUDIO / VIDEO OUTPUT (1) can not be controlled by the MODE button. AUDIO / VIDEO OUTPUT (2) is controlled by the MODE button, and you can change it among DVD, AV IN 1 and AV IN 2. REPEAT PLAY/ PARAGRAPH REPEAT PLAY Repeat play: When you want to repeat the whole disc or a track or a chapter in the disc. The meaning of the levels 1 to 8 varies depending upon the country and the type of content on the disc. The parental control levels are: 1 2 3 4 5 6 7 8 Unlock KID SAFE G PG PG 13 PG-R R NC 17 ADULT SPECIAL FUNCTIONS FOR VCD AND CD For VCD and CD discs, there is one special function "Program Play" which makes it different from DVD discs. For how to set the program menu, please refer to the operation of the audio files in the media player below. note: · After you have programmed the tracks, press the PROGRAM button to switch between program play and normal play. DATA DISC PLAY OPERATION When you insert a data disc including audio (MP3, WMA), movie (MPEG), picture (JPG) files into the disc slot, the following media play window will be shown on the screen: MEMORY CARD OPERATION There is a memory card interface on the front panel of the unit. Using the SD/MMC/MS card: 1) When there is no disc in the disc slot and no USB driver is connected, and you insert memory card into the memory card interface, the unit will read the card automatically. 2) When there is a disc in the disc slot or when a USB drive is connected, and you insert a memory card, the unit will play the disc or read the USB drive. Press the (stop) or the (pause) button to enter STOP or PAUSE mode, then press the GOTO button to enter the reading card mode. Note: When reading the memory card, please don't touch or take out the card. If you followed the instruction above, and the unit can't read the card, please check if the card is in good condition, or take out the card then insert it into the card interface once more. USB PLAY OPERATION On the front panel of the unit, there is an USB interface. [. . . ] Under no circumstances should you try to repair the player yourself, as this will invalidate the warranty. Only qualified service personnel can remove the cover or service this player. nO POWER · Check if the on/off button on the front of the player is set to ON. ⷠCheck if the AC or DC power plug of the mains unit is properly connected. [. . . ]