User manual LENCO CS-176

[. . . ] GROUND 8 FUSE 15A 6 5 4 2 A 7 3 1 Detaching and attaching the front panel The front panel of this unit can be detached in order to prevent the unit from being stolen. 8 6 4 2 B DETACHING THE FRONT PANEL Before detaching the front panel, be sure to press the PWR button to turn off the unit first. Then press the button and detach the panel by pulling it towards you as illustrated. Note: Be sure not to drop the panel when detaching it from the unit. Note: The connector A no. 7 must be connected by car ignition key in order to avoid that car battery becomes weak when the car will be not used for long period. 7 5 3 1 CONNECTOR B 1. REAR RIGHT SPEAKER(+) REAR RIGHT SPEAKER(-) FRONT RIGHT SPEAKER(+) FRONT RIGHT SPEAKER(-) FRONT LEFT SPEAKER(+) FRONT LEFT SPEAKER(-) REAR LEFT SPEAKER(+) REAR LEFT SPEAKER(-) ATTACHING THE FRONT PANEL Make sure the front panel is the right way up when attaching it to the unit as it cannot be attached upside down. [. . . ] When AF/REG switching mode is selected, the radio checks the signal strength of the AF all the time. -Regional mode ON: AF switching or PI SEEK is implemented to the station which have all PI codes same as current station. REG segment is turned on in LCD display. 7 English (B) CD/MP3/SD/MMC/USB MODE By pressing this key, user can execute search function. English 8 2 -Regional mode OFF The regional code in the format of PI code is ignored when AF switching or PI SEEK is implemented. 6. "TP" function(TRAFFIC PROGRAM) When press short, it is activated as TP mode on or off. -When the unit is in CD/MP3 mode, it will switch to radio mode temporarily. -If the volume level was under the threshold point, it will be raised to the threshold point. -When TP station is received, TP segment is turned on in LCD display. (C)SUB WOOFER Press "BND" W button for more than 2sec. will open SUB LINE-OUT in any modes, and the LCD will display "SUB W". AUTOMATIC OR MANUAL TUNING (FREQ UP : OR FREQ DOWN 9 ) (A) RADIO MODE When press less than 1 sec, they are operated as SEEK tuning mode. When press longer than 1 sec. , they are operated as MANUAL tuning mode. (B) CD/MP3/SD/MMC/USB MODE When press less than 1 sec, they are operated as TRACK UP/DOWN mode. When press longer than 1 sec. , they are operated as FORWARD or REVERSE mode. ` 7. "PTY" function(PROGRAM TYPE) PTY MUSIC---PTY SPEECH---PTY OFF While selecting PTY type, its selection is impremented by select buttons as described in preset key. When PTY is selected, the radio starts to search corresponing PTY informa tion, and stops if the corresponding PTY information is detected. 12. With clock display selected, hold down the "DSP" button until clock display starts flashing. (A) RADIO MODE By pressing shortly, the radio searches for each preset station. When field strength level is bigger than the threshold level of stop level, the radio is holding at that preset number for 5 sec. with releasing mute, channel is flashing during the process, then searches again. By pressing longer than 1 sec, AUTO MEMORY is activated and then 6 strongest stations are preset to the corresponding preset number. (B) CD/MP3/SD/MMC/USB MODE Press this button to start search track or file. 9. MODE BUTTON(MD) By pressing this key, user can select RADIO mode , CD/MP3/WMA PLAYER mode, SD/ MMC /USB mode. 10. BAND sub woofer BUTTON(BND/SUB) (A) RADIO MODE Each band is toggled cyclically by pressing this key FM1-FM2-FM3 13. LCD DISPLAY The liquid Crystal Display will display the current state of the unit. 14. PANEL RELEASE BUTTON Press this button (14) to release the front panel. [. . . ] Press this key at first, filenumber search function is activated, press again, filename searc function, and finally exits search function. Filenumber search " filename search " exit search (1) Filenumber search When three digits of zeros are displayedin CD/USB/SD/MMC mode, it means ready to get the file number. You can press M1, M2, M3, M4, M5, M6 to select the track you want (as illustrated): - 0 0 0 - NUMBER OF TOTAL SONG IS LESS THAN 1000 - 0 0 0 0 - NUMBER OF TO TAL SONG IS MORE THAN 1000 When press M1, then the unit will display "*0 0 1" When press M2, then the unit will display "*0 1 2" When press M3, then the unit will display "* 1 2 3" . . . . . . (If number seat is exceed, automatic scroll) After select track you want, press "BAND" button to confirm and the unit start playback ( if there is no number, last song play). (2) Filename search Filemame search function requires only three characters. [. . . ]