User manual LENCO CR-222

[. . . ] DIGITAL ALARM CLOCK RADIO INSTRUCTION MANUAL MODEL: CR-222 LOCATIONS OF PARTS AND CONTROLS 1. [. . . ] In case of malfunction due to electrostatic discharge, the apparatus has to be reset by disconnecting it from mains supply. THE MARKING PLATE IS LOCATED AT THE BOTTOM OF ENCLOSURE OF THE APPARATUS. GB 1 POWER SUPPLY AC power : 230V ~ 50 Hz DC power : 3V battery type "AAA" (not provided) for clock back-up system only. For optimum performance, this battery should be replaced every 6 months. Connect the 2 x 1. 5V battery inside the compartment at the bottom of the unit . TO SET THE TIME Hold the TIME button for 2 seconds and press HOUR > (+) or < HOUR (-) to set the hour digit, hold the TIME for 2 seconds and press MINUTE > (+) or < MINUTE (-) to set the minute digit. TO POWER ON RADIO Press the RADIO button to turn the radio on, press again to turn off. SETTING THE ALARM Hold the ALARM 1-SET/OFF button for 2 seconds and press HOUR > (+) or < HOUR (-) to set the ALARM 1 hour digit, hold the ALARM-SET/OFF and press MINUTE > (+) or < MINUTE (-) to set the ALARM 1 minute digit. Hold the ALARM 2-SET/OFF button for 2 seconds and press HOUR > (+) or < HOUR (-) to set the ALARM 2 hour digit, hold the ALARM 2-SET/OFF and press MINUTE > (+) or < MINUTE (-) to set the ALARM 2 minute digit, the ALARM 2 will show on alarm display when ALARM 2-SET/OFF button is pressed. [. . . ] If at any time in the future you should need to dispose of this product please note that: Waste electrical products should not be disposed of with household waste. [. . . ]