User manual LASERLINE 921T

[. . . ] Activation of the system is automatically carried out approximately 20 seconds after switching the ignition off. From now on, the immobiliser operates on two specific points of the vehicles starting-ignition or fuel supply systems, to prevent an unauthorised attempt to start the vehicle. To switch the immobiliser off, move the coded TRANSPONDER KEY to the reader and remove. If you fail to start the vehicle within this 20 seconds the system will reactivate automatically and it will be necessary to move the coded TRANSPONDER KEY to the reader and remove again in order to start the vehicle. [. . . ] 4 ) The LED will start to flash and the immobiliser is ready to accept the PIN CODE. Turn ON the ignition key for 1 second after the LED as displayed the flashes corresponding to each digit of your PIN CODE, read PIN CODE at the end of these instructions from left to right. If the inserted PIN CODE is correct, the immobiliser will disarm itself and automatically enter the "SELFLEARNING PROCEDURE", signaling this condition by LED ON for 10". If the inserted PIN CODE is wrong, the immobiliser will remain ON. Note After the above operations, any lost or stolen TRANSPONDER KEYS become useless. No more than 10 seconds must elapse between memorising each TRANSPONDER KEY. When 4 TRANSPONDER KEY have been memorised, the immobiliser will automatically exit from the selflearning procedure or 10 seconds after the last TRANSPONDER KEY was memorised. If a new TRANSPONDER KEY has been memorised, it is necessary to memorise the original TRANSPONDER KEYS if their continued use is desired. If only one TRANSPONDER KEY is available no SELF-LEARNING PROCEDURE will take place and the procedure will enter EMERGENCY CODE (PIN CODE) DISPLAY PROCEDURE. To memorise only one TRANSPONDER KEY follow the "USING THE EMERGENCY CODE (PIN CODE) TO DISARM THE IMMOBILISER" procedure and memorise single TRANSPONDER KEY. LIFETIME WARRANTY Product warranty covers units to be free from defects in manufacture for the lifetime ownership of the original vehicle, in accordance with the terms and conditions of this warranty document. Any product, which is deemed to be defective, will be replaced or repaired. Accessories including remote controls, touch keys and additional modules are guaranteed for a period of 12 months from date of installation. Terms and Conditions 1. If product is transferred by an authorised installer onto another vehicle then in this case the warranty reverts back to 2 years from the date of the original installation. Warranty is not transferable by the original customer to other owners of the product or accessory. The customer must complete and return the warranty registration document within 21 daysfrom date of purchase in order for the warranty to be valid. , 5. The warranty covers product only and not the quality of the installation. We cannot be held responsible for costs arising due to incorrect installation. All warranty claims must be directed through the original installer, accompanied by the original invoice, detailing date of installation and annual service record. Continuance of product warranty is subject to an annual product service check for which a small charge may be levied by any authorised installer. Evidence of service check record must be provided in support of warranty claims. Warranty does not cover costs incurred for breakdown assistance or vehicle recovery, due to product or accessory failure. [. . . ] After the sixth flash has been completed and the LED has turned OFF, immediately turn ON the ignition key for 1". Turn the ignition OFF and after a pause, the LED will flash for the next digit of the PIN CODE; Third digits 0 - For the 0 digit, the flashes to be completed on the LED are 10. Continue until all the digits have been displayed and inputted correctly. USER MANUAL IMMOBILISER MODEL 921T YOUR PIN CODED IS: IMMOBILISER WITH TRANSPONDER KEY FOR ALL CARS WITH 12V NEGATIVE EARTH ELECTRICAL SYSTEMS NOTE Manufacturer declines any responsibility for damage of the immobiliser and the vehicle electrical system due to WRONG INSTALLATION OR TAMPERING. LASERLINE SpA RESERVES THE RIGHT TO EFFECT CHANGES OF THE PRODUCT WITHOUT FURTHER NOTICE. [. . . ]