User manual LA CROSSE TECHNOLOGY WT-2160 INSTRUCTION MANUAL

[. . . ] SETTING THE TIME There are two methods by which the time and date can be set: 1) Automatically via WWVB reception, or 2) Manually. B. WWVB (Radio-Controlled Time) This method requires you to do nothing, except wait for the signal to be received, and to select a time zone. Reception usually takes approximately 6-10 minutes during optimal conditions. The best conditions for reception is at night, between midnight and 6:00 am--when there is less atmospheric interference. [. . . ] b) "Sno" will show at the bottom of the screen, and a number will flash at the top. Press the "+" key to advance the length from 0 (no snooze)) to 59 minutes. This sets the time the alarm is silenced after pressing the SNOOZE key while the alarm is sounding. Press the "+" key to advance to the correct hour; be sure to note the correct am/pm setting ("PM" will show for pm setting, nothing for the am setting). By holding the "+" key, the minutes will advance in five minute increments. Press the "+" key to advance to the correct day of the week. Press the "+" key to select either 12 ­hour or 24-hour (military time). PROGRAMMING SEQUENCE Time ZoneDST On/OFFSnooze SettingHourMinuteYearMonthDateDay12/24 hour format III. SETTING THE ALARMS La Crosse Technology's travel alarm clock has two separate alarms that can be set. Press and hold the "ALM1" (or "ALM2" key) key for two seconds to enter the setting mode. Press the "HOUR" key to advance the hour of the alarm, and press the "MIN" key to advance the minutes of the alarm. If no button is pressed within fifteen seconds, the alarm will set and will activate, and the clock will revert to the normal operating screen. To activate/deactivate the alarm, press the "ALM1" or "ALM2" key once, depending on which alarm needs to be activated. "Alarm 1" activated "Alarm 2" activated C. When the alarm is sounding, pressing the "SNOOZE" bar will turn it off for the time that was selected in the programming mode (section II. A. 2. c. ). If the setting is "0", the alarm will turn off for 24 hours. During the snooze period, the lower screen will show a countdown until the alarm will sound again. If the snooze bar is pressed again during the original snooze period, the period will be reset. Pressing any key other than the snooze key will turn off the alarm for 24 hours. IV. The exact time will always be displayed in the upper portion of the screen, and the US map will show when the time zone is set to the continental US (with the time zone selected showing in black). The lower portion of the screen has five different screens that can be selected. While in non-alarm mode, pressing the "SNOOZE" bar will show the "ALARM1" and "ALARM2" briefly in the lower section. V. When traveling, it will only be necessary to change to the appropriate time zone. Please note that the clock will only search for a signal when it is set between "GMT-4 and GMT-10. The alarm clock will set to any time zone from "GMT" to "GMT-12". [. . . ] This warranty does not cover any defects resulting from improper use, unauthorized repairs, faulty batteries, or the units' inability to receive a signal due to any source of interference. LA CROSSE TECHNOLOGY WILL NOT ASSUME LIABILITY FOR INCIDENTAL, CONSEQUENTIAL, PUNITIVE, OR OTHER SIMILAR DAMAGES ASSOCIATED WITH THE OPERATION OR MALFUNCTION OF THIS UNIT. THIS PRODUCT IS NOT TO BE USED FOR MEDICAL PURPOSES OR FOR PUBLIC INFORMATION. Some States do not allow the exclusion of consequential or incidental damages; therefore the above exclusion of limitation may not apply to you. [. . . ]