User manual LA CROSSE TECHNOLOGY WS-8300U-IT

[. . . ] Each obstruction (roof, walls, floors, ceilings, thick trees, etc. ) will effectively cut signal range in half. Example: A wireless weather station receiver with a 330 feet range is mounted on an interior wall, so that the signal has to pass through one interior wall, one exterior wall, and across the 10 foot width of the room between the 2 walls. The first wall will reduce the range to 165 feet, and the second wall will reduce the range to 87 feet. Factoring in the 10 foot room, this leaves a maximum of 77 feet of remaining signal range. [. . . ] "MAX" appears at the bottom of the LCD and the maximum temperatures and humidity are displayed. Press and release the MIN/MAX button once more to return to the current temperatures and humidity. RESETTING THE MINIMUM AND MAXIMUM TEMPERATURES AND HUMIDITY To reset both the minimum and maximum temperatures and humidity--press and hold the MIN/MAX button for 5 seconds. ADDING ADDITIONAL REMOTE SENSORS (OPTIONAL) The WS-8300U is able to receive signals from 2 additional thermo-hygro sensors . The following are instructions for the set-up of thermo-hygro sensor units with the WS8300U. These extra sensors can be purchased through the same dealer as this unit. Remove all the batteries from the receiver and sensor(s) and wait 60 seconds. During these 60 seconds, press any button 20 times to discharge any excess power. Within 2 minutes of powering up the first sensor, insert the batteries to the Weather Station. Once the batteries are in place, all segments of the LCD will light up briefly. Following the indoor temperature and the time as 12:00 will be 7 displayed. If they are not shown in LCD after 60 seconds, remove the batteries and wait for at least 60 seconds before reinserting them. The outdoor temperature and humidity from the first sensor (channel 1) should then be displayed on the Weather station. If this does not happen and the signal reception icon is not shown, after 2 minutes, the batteries will need to be removed from both units and reset from step 1. Insert the batteries to the second sensor as soon as the outdoor temperature and humidity readings from the first sensor are displayed on the Weather station. NOTE: You must insert the batteries into the second sensor within 30 seconds of reception of the first sensor. The outdoor temperature and humidity from the second sensor and the "channel 2" icon should then be displayed on the Weather station. If this does not happen after 2 minute, the batteries will need to be removed from all the units and reset from step 1. Insert the batteries to the third sensor as soon as the "channel 2" icon and outdoor data are displayed on the Weather station. Then within 2 minutes, the channel 3 outdoor data from the third sensor will be displayed and the channel icon will shift back to "1" once the third sensor is successfully received. NOTE: You must insert the batteries into the third sensor within 30 seconds of reception of the second sensor. IMPORTANT: Transmission problems will arise if the setting for multiple sensors is not followed as described above. [. . . ] LA CROSSE TECHNOLOGY, LTD WILL NOT ASSUME LIABILITY FOR INCIDENTAL, CONSEQUENTIAL, PUNITIVE, OR OTHER SIMILAR DAMAGES ASSOCIATED WITH THE OPERATION OR MALFUNCTION OF THIS PRODUCT. THIS PRODUCT IS NOT TO BE USED FOR MEDICAL PURPOSES OR FOR PUBLIC INFORMATION. KEEP OUT OF CHILDREN'S REACH. 11 This warranty gives you specific legal rights. Some States do no allow the exclusion of consequential or incidental damages therefore the above exclusion of limitation may not apply to you. [. . . ]