User manual KYOSHO MINI-Z OVERLAND

[. . . ] As the front end of the antenna may be dangerous, do not swing or aim it toward faces. Even when the power on the MINI-Z model is switched OFF, there is still a low current flowing. In order to turn the power OFF completely, all batteries must be removed from the model. [. . . ] Wheels and tires included with this set can be used with any body set. If using the wheels and tires included with the body set, refer to the section 'Tires' in '8 Replacing Each Part' and install accordingly. If it is not easy to remove the battery holder, try with a flat blade screwdriver. Instructions from this point onwards relate to use with the PERFEX KT-18 transmitter. If using a different transmitter, refer to the instructions included with your transmitter. To use this transmitter with a previously purchased chassis (MINI-Z OVERLAND), it must undergo a pairing adjustment. When the LED goes out after about 3 seconds, release finger from the Throttle Trim. Once the LED indicator light has dimmed, the preparation of the transmitter is complete. Prepare pairing stick and locate the LED indicator and pairing button. Light is ON : Pairing has been successful Light is flashing : Pairing has not be completed. Appliances such as a microwave oven are emitting strong electrical waves are being used close by. With throttle trigger in neutral, click Throttle Trim one click at a time until car stops and continuous beep stops. Beeping sound will start when neutral is found or range limit is reached. Raise the tires off the ground and check that all controls are responding. [. . . ] For replacement, refer to the chart and use proper combination with pinion and spacer. This receiver is the first RC to be equipped with an interactive data communication function with a personal computer. This enables machine settings to be done externally through the computer. [. . . ]