User manual KRESS CST 6235 E

[. . . ] Safety instructions and prevention of accidents Before operating the machine, please read through the operating instructions completely, follow the Safety Instructions in this manual as well as the general Safety Instructions for Power Tools in the accompanying booklet. Always remove the mains connector from the appliance before making changes to the tool. Never put your hands in the vicinity of the tappet or saw blade (7) while the machine is running ­ risk of injury. To avoid injuries, wear protective gloves when changing the saw blade. [. . . ] Working with pendulum jigsaws When sawing, ensure that the base plate is securely positioned on the work piece. To achieve clean cuts and optimal cutting performance, ensure that the pendulum stroke setting and forward feed selected are appropriate to the material (e. The built-in blower keeps the cut continuously free of shavings for perfect visibility. sheet metal is to be clamped to a suitably solid base (clamping plate or plywood plate). This eliminates as far as possible the risk of the material springing back and forth. Plunge cuts can be made into the material (only when working wood), but should only be attempted by skilled people. The switched-on jigsaw is placed on the work piece at an angle of 55­60° to the front edge of the base plate and pushed down slowly and carefully. Particular care is required at the start of this work; kick-backs and jerks will result if the jigsaw is placed the wrong way, whilst excessively fast plunge cuts may result in broken blades. adjustments are made by loosening the clamping wheel (6) beneath the handle. As soon as the toothed wheel work of the saw bench mounting is released, the base plate (4) can be turned to positions 22. 5° or 45° and be tightened again with the clamping wheel (6). 5 Full-wave control electronics The electronic pendulum jigsaw is equipped with control electronics which can be switched off. The stroke rate can be continuously adopted within a range from 450-2000 strokes per minute to the respective material requirements. adjustment is by means of an electronic-adjusting wheel (2) in the housing. The electronics are switched off by turning the adjusting wheel to the max. The motor can become overheated with longterm heaving loading and low rev. Chip-flyoff guard The synthetic part is placed into the saw opening of the base plate from below (snap fastening). The wood fibre structure is thereby pressed during sawing against this chip-flyoff guard, thus preventing the wood fibres from being damaged. This application can only be used when cutting at a right angle (90°). In order to keep the cut free of shavings, the flexible suction tube is inserted from the back into the housing opening. [. . . ] The guarantee may only be enforced when defects are reported without undue delay (including shipping damage). If the tool is defective, please complete the guarantee card and return the unit, guarantee card and a brief description of the problem to the responsible service location. The guarantee obligations assumed by us shall exclude any further claims on the part of the buyer, in particular the right to recission of a sale, reduction and the assertion of damage claims. However, the buyer shall have the right to either a reduction (in the purchase price) or the recission of the sale (cancellation of the sales agreement) should we fail to eliminate any defects within a reasonable period of time. [. . . ]