User manual KRESS 650 BS

[. . . ] Never use the cord for carrying, pulling or unplugging the power tool. When operating a power tool outdoors, use an extension cord suitable for outdoor use. Use of a cord suitable for outdoor use reduces the risk of electric shock. If operating a power tool in a damp location is unavoidable, use a residual current device (RCD) protected supply. [. . . ] Although this information sheet and the operating manuals for our electrical tools contain extensive instructions on safe working with electrical tools, every electrical tool involves certain residual risks that cannot be completely prevented through safety mechanisms. Therefore, electrical tools must always be operated with the necessary caution. Failure to follow the warnings and instructions may result in electric shock, fire and/or serious injury. While reading the operating instructions, unfold the graphics page for the machine and leave it open. Jig saw V~ Nominal voltage Watt Input power Watt Output power 340 650 650 BS 230 Min-1 Idling speed stroke number n0 min-1 Standard stroke range mm Stroke height 10 Stop lever 11 Mains cable module 12 Interlock button 13 Chip-flyoff guard (plastic) 14 Sliding block 15 Chip-flyoff guard (steel) 16 Plastic cap (insulated gripping surface) 17 Handle (insulated gripping surface) Scope of supply See packaging Cutting capacity, max. In wood non alloy steel mm light metal mm 6 16 mm 110 19 The machine is intended for making separating cuts and cut-outs in wood, plastic, metal, ceramic plates and rubber while resting firmly on the workpiece. It is suitable for straight and curved cuts with mitre angles to 45°. Kg 2, 3 Weight Your power tool is double-insulated in accordance with EN 60745; For this reason an earth wire is not required. The device is suppressed against radio and TV broadcasts, in accordance with EN 55014-1 and is immune to disturbances in accordance with EN 55014-2. Typically the A-weighted noise levels of the machine are: sound pressure level (LpA) 84 dB (A) 95 dB (A) sound power level (LwA) Measurement uncertainty K=3 dB The noise level can exceed 85 dB(A) during operation. Vibration Triaxial vibration emission level determined in accordance with EN 60745. to switch on the device , slide the circuit closer/breaker 1 to the front. Pressing the swung-out front edge of the circuit closer/breaker 1 will move it back to the Off position. Restarting protection The restarting protection feature prevents uncontrolled restarting of the machine after an interruption in the power supply. to restart the operation , switch the On/Off switch 1 to the Off position and start the machine again. Pendulum stroke setting The change-over from the setting 0-3 is effected by means of the pendulum-stroke adjusting knob 7 (turning knob). It should be noted that the values given are standard values which may vary according to thickness and hardness of material, grain direction, and also to the condition of the saw blade. The optimal orbital action setting for the respective application can be determined through practical testing. The following recommendations apply: Select a lower orbital action setting (or switch it off) for a finer and cleaner cutting edge. For soft materials and when sawing in the diSPS-EN / 0912 Operation The wood fibres are thus pressed against the stress corrosion protection 13 or 15 during sawing, which prevents the edges being torn. It is only by doing this that the secure clamping of the saw blade 8 can be ensured and the hood 3 can be closed. Disconnect the plug from the power source before making any adjustments, changing accessories, or storing power tools. [. . . ] Wipe off the accessible plastic parts regularly with a cloth without cleaning agent. The movable supporting roller for the saw blade should be given a drop of oil from time to time. The saw blade should not be longer than required for the intended cut. Parallel fence (accessory) For perfect results with parallel cuts use the graduated parallel fence 5. [. . . ]