User manual KRESS 6165 A

[. . . ] Initial operation Before the first operation check that the mains voltage corresponds to that given on the machine nameplate. To release the continuous operation, merely depress the switch which makes the holding button spring back automatically. Full-wave electronic control (6175 EA) This sander incorporates a full-wave electronic control to adjust required speed merely by applying power at the on/off switch. Any speed within the orbital and stroking range can be additionally engaged by means of a locking wheel. [. . . ] Safety instructions and prevention of accidents Before operating the machine, please read through the operating instructions completely, follow the Safety Instructions in this manual as well as the general Safety Instructions for Power Tools in the accompanying booklet. Always pull the power plug when making any adjustments on the machine. When completing large sanding jobs without dust extraction, it is advisable to wear a breathing mask. The blowout port on the blower flange must be closed with the cover (9) supplied. Wear ear protection when working with the machine for prolonged periods. Operate the orbital sander from an isolating transformer when wet grinding. Outside power sockets must be protected with residual-current-operated circuit-breakers (r. Double insulation Our equipment is designed in accordance with European regulations (EN standards) for the utmost safety of the user. Machines with double insulation always carry the international symbol. Wrap the abrasive paper around the sanding shoe, place it under the second clamp and tighten. Operating Orbital Sander Best results are obtained from the orbital sander by sanding one path after the other. Begin with a rough abrasive paper and continue through the fine grades until the surface finish desired is obtained. A high working pressure reduces the number of orbits, and consequently the sanding capacity. The machine should be running before it is placed on the workpiece and switched off again after it has left the workpiece (this prevents scratches as motor dies out). Maintenance and Upkeep Any tool used work with wood will be covered with dust. All moving parts of the machine receive sufficient lubrication before leaving the factory. Replacing carbon brushes Our service personnel will carry out this and other servicing work fast and professionally. Thanks to the new mains cable (10) with patent quick-action lock this could not be more simple. Press the two lock push-buttons (11) and pull the mains cable (10) out of the handle. Only use mains cables with patent quick-action lock for KRESS power tools! [. . . ] The guarantee will be rendered void if the device is used improperly, mistreated or opened up by unauthorised repair personnel. The guarantee may only be enforced when defects are reported without undue delay (including shipping damage). If the tool is defective, please complete the guarantee card and return the unit, guarantee card and a brief description of the problem to the responsible service location. The guarantee obligations assumed by us shall exclude any further claims on the part of the buyer, in particular the right to recission of a sale, reduction and the assertion of damage claims. [. . . ]