User manual KENWOOD KDC-W410

[. . . ] Make sure not to get your fingers caught between the faceplate and the unit. Do not touch the liquid crystal fluid if the LCD is damaged or broken due to shock. The liquid crystal fluid may be dangerous to your health or even fatal. If the liquid crystal fluid from the LCD contacts your body or clothing, wash it off with soap immediately. [. . . ] Enter Audio Control mode Press the [AUD] button for at least 1 second. Each time the button is pressed the items that can be adjusted switch as shown below. Adjustment Item Display Bass level "Bass" Middle level "Middle" Treble level "Treble" Balance "Balance" Fader "Fader" Volume offset "V-Offset" Volume offset: Each source's volume can be set as a difference from the basic volume. In CD & External disc source Information Disc title Track title Play time & Track number Disc name Clock In MP3 source Information Song title & Artist name Album name & Artist name Folder name File name Play time & Track number Disc name Clock In Auxiliary input source Information Auxiliary input name Clock Display "D-TITLE" "T-TITLE" "P-Time" "DNPS" The faceplate of the unit can be detached and taken with you, helping to deter theft. The faceplate is a precision piece of equipment and can be damaged by shocks or jolts. For that reason, keep the faceplate in its special storage case while detached. Do not expose the faceplate or its storage case to direct sunlight or excessive heat or humidity. Also avoid places with too much dust or the possibility of water splashing. If the Disc title, Track title, Song title & Artist name, or Album name & Artist name is selected when the disc which does not have Disc title, Track title, Song title, Album name, or Artist name is played, track number and play time are displayed. the "CALL" display disappears and the audio system comes back ON. Each time the [FM] button is pressed it switches between the FM1, FM2, and FM3 bands. Display examples: Display Disc player "CD2" CD player "DISC CH" CD changer / MD changer The functions that can be used and the information that can be displayed will differ depending on the external disc players being connected. If the remote with number buttons is used as optional accessories, a song you'd like to listen to can directly be selected with the operation below. Example: When you want to set the beep sound select the "Beep" display. When other items that are applicable to the basic operation method above are displayed afterwards their setting content chart is entered. Enter Clock Adjust mode Press the [4] or [¢] button for at least 1 second. A red indicator will blink on the unit after the faceplate is removed, warning potential thieves. display and Setting "NEWS OFF" "NEWS 00MIN" "NEWS 90MIN" When "NEWS 00MIN" -- "NEWS 90MIN" is set , the News Bulletin Interrupt function is ON. When the news bulletin starts, "News" is displayed, and it switches to the news bulletin. If you choose the "20MIN" setting, further news bulletins will not be received for 20 minutes once the first news bulletin is received. The news bulletin volume is the same level that was set for <Traffic Information> (page 14). This function is only available if the desired station sends PTY-code for news bulletin or belongs to <Enhanced Other Network>Network sending PTY-code for news bulletin. [. . . ] Pull the unit all the way out with your hands, being careful not to drop it. What might seem to be a malfunction in your unit may just be the result of slight misoperation or miswiring. Before calling service, first check the following table for possible problems. After checking for short circuits in the wires, replace the fuse with one with the same rating. [. . . ]