User manual KENWOOD DPX-U5130

[. . . ] Com/edition/im369/ ¤ CAUTION • Keep battery out of reach of children and in original package until ready to use. € The battery pack or batteries shall not be exposed to excessive heat such as sunshine, fire or the like. € Do not set the remote control in hot places such as on the dashboard. • The Lithium battery is in danger of explosion if replaced incorrectly. [. . . ] Connecting the iPod touch or iPhone to this unit with USB cable will automatically register it as a Bluetooth device. The Bluetooth function of the iPod touch or iPhone is turned on first. 1 Before Installation 2WARNING • The unit can only be installed in a car with a 12V DC power supply, negative ground. € If you connect the ignition wire (red) and the battery wire (yellow) to the car chassis (ground), you may cause a short circuit, that in turn may start a fire. Always connect those wires to the power source running through the fuse box. CAUTION • Mounting and wiring this product requires skills and experience. For safety’s sake, leave the mounting and wiring work to professionals. € Do not install the unit in a spot exposed to direct sunlight or excessive heat or humidity. Also avoid places with too much dust or the possibility of water splashing. € If the power is not turned ON (“PROTECT” is displayed), the speaker wire may have a shortcircuit or touched the chassis of the vehicle and the protection function may have been activated. € If your car’s ignition key switch does not have an ACC position, connect the ignition wires to a power source that can be turned on and off with the ignition key. € A broadcast station or walkie-talkie located nearby can interfere with communication due to a too strong signal. Unit Battery cable (Yellow) Vehicle A-4 Pin (Yellow) 2 The A-7 pin (red) of the vehicle’s ISO connector is connected to the constant power supply, and the A-4 pin (yellow) is linked to the ignition. ignition cable (Red) A-7 Pin (Red) Unit Battery cable (Yellow) Vehicle A-4 Pin (Yellow) !Do not touch the metal parts of this unit during and shortly after use of the unit. Indd 9 12/11/21 15:0 Connecting Wires to Terminals Microphone input (DPX-U5130 only) Microphone (Accessory4) R L Antenna Cord Connector Function Guide Pin Numbers for ISO Connectors External Power Connector A-4 A-5 A-6 A-7 A-8 Speaker Connector B-1 B-2 B-3 B-4 B-5 B-6 B-7 B-8 Cable Colour Functions FM/AM antenna input (JASO) Yellow Blue/White Orange/White Red Black Battery Power Control Dimmer Ignition (ACC) Earth (Ground) Connection Rear Right (+) Rear Right (–) Front Right (+) Front Right (–) Front Left (+) Front Left (–) Rear Left (+) Rear Left (–) Purple Purple/Black Gray Gray/Black White White/Black Green Green/Black ⁄ See <Connecting the ISO Connector> (page 9). connector A Connector B 8 7 8 7 6 5 6 5 4 3 4 3 2 1 2 1 Yellow (A–4 Pin) Red (A–7 Pin) Yellow (Battery wire) Red (Ignition wire) 10 | Quick Start Guide B59-2160-00_00_13-2DIN_QSG_E_en. 1 2 Remove the trim plate by referring to the removal procedure in the section <Removing the trim plate>. Insert the two extraction keys (Accessory 3) deeply into the slots on each side, as shown. Accessory 3 1 ⁄ • Install the microphone as far as possible from the cell-phone. Accessory 4 3 Lower the extraction key toward the bottom, and pull out the unit halfway while pressing towards the inside. Peel off the release coated paper of double-face adhesive tape to secure the microphone on the place shown above. [. . . ] Please note that the use of this accessory with iPod or iPhone may affect wireless performance. € Internet Explorer and Windows Media are registered trademark of Microsoft Corporation in the United States and other countries. € Firefox is a registered trademark of Mozilla Foundation in the United States and other countries. € aha, the Aha logo, and the Aha trade dress are trademarks or registered trademarks of HARMAN International Industries, used with permission. [. . . ]