User manual KENWOOD DDX896

[. . . ] 6 2 DNX SERIES/ DDX SERIES    DFPKA$ properly, the front panel will automatically move into the position (initial setting angle) shown in (Fig. 2) After the Installation After the installation, perform the Initial Setup by referring to the instruction manual. ⤠• Mounting and wiring this product requires skills and experience. €¢ Make sure to ground the unit to a negative 12V DC power supply. [. . . ] Blocking these openings will inhibit the cooling of the internal temperature and result in malfunction. €¢ Do not press hard on the panel surface when installing the unit to the vehicle. €¢ Reception may drop if there are metal objects near the Bluetooth antenna. Bluetooth antenna unit ¤ CAUTION Install this unit in the console of your vehicle. Do not touch the metal part of this unit during and shortly after the use of the unit. English 3    DFPKA$ Connection Ignition key switch ACC Ignition wire (Red) Battery wire (Yellow) Car fuse box (Main fuse) Car fuse box Ground wire (Black) (To car chassis) Antenna Cord FM/AM antenna input ignition (red) and battery wire (yellow) ¤ If you connect the(ground), wire may causetheshort circuit, that in to the car chassis you a turn may start a fire. Always connect those wires to the power source running through the fuse box. a A Battery ⁄ Connect to the vehicle's parking brake detection switch harness. Parking sensor wire (Light Green) PRK SW For best safety, be sure to connect the parking sensor. Connect to vehicle's reverse lamp harness when using the optional rear view camera. To steering remote To use the steering wheel remote control feature, you need to an exclusive remote adapter (not supplied) matched to your car is required. „ To car light control switch Connect to the terminal that is grounded when either the telephone rings or during conversation. „ To connect the Kenwood navigation system, consult your navigation manual. Depending on what antenna you are using, connect either to the control terminal of the motor antenna, or to the power terminal for the booster amplifier of the film-type antenna. When using the optional power amplifier, connect to its power control terminal. „ 4 If no connections are made, do not let the cable come out from the tab. dNX SERIES/ DDX SERIES    DFPKA$ Bluetooth Microphone (Accessory #) (see page 8) Voice Control Switch(Accessory $) (DNX9960 only) (see page 8) Cooling fan GPS Antenna (Accessory !) (DNX9960 only) (see page 8) FUSE (15A ) Accessory 1 Reverse sensor wire (Purple/White) REVERSE To front left speaker White/Black White + Steering remote control input (Light Blue/Yellow) REMOTE CONT STEERING WHEEL REMOTE INPUT To front right speaker Gray/Black Gray + Dimmer control wire (Orange/White) ILLUMI Mute control wire (Brown) MUTE To rear left speaker Green/Black Green + Motorized antenna control wire (Blue) ANT. 5φ) Accessory % (DNX9960 only) ⁄ Accessory 3 Accessory 4 AV OUT When connecting the TMC Tuner GTM10 (optional accessory), put the cable clamper (accessory %) to the back of this unit first, and then wire the cable through the clamper. Accessory 2 Audio/Visual Output • Visual output (Yellow) • Audio left output (White) • Audio right output (Red) Audio/Visual Input • Visual input (Yellow) • Audio left input (White) • Audio right input (Red) Audio/Visual Input • Visual input (Yellow) • Audio left input (White) • Audio right input (Red) Rear View Camera Input • Visual input (Yellow) Front Preout • Audio left output (White) • Audio right output (Red) Rear Preout • Audio left output (White) • Audio right output (Red) Subwoofer Preout • Audio left output (White) • Audio right output (Red) Center Preout (Green/Red) AV IN 2 (Green/White) REAR VIEW CAMERA CENTER SUB WOOFER REAR FRONT To Relay Box RELAY 1 RELAY 2 (Blue/Red) (Blue/Red) 6 DNX SERIES/ DDX SERIES AV IN1 To Camera control terminal    DFPKA$ Optional Accessory Connection iPod (commercially available) KCA-iP301V (Optional Accessory) Visual Output (Yellow) Audio Output (Black) iPod DDX896/DDX8046BT only USB terminal USB terminal USB device (commercially available) To SIRIUS Satellite Radio tuner/ XM Satellite Radio tuner/ HD Radio tuner (Optional Accessory) ⁄ Conversion adapter (optional accessory) may be necessary for connection of optional accessory. TV Tuner (Optional Accessory) TV ANTENNA INPUT Navigation System (Optional Accessory) (DDX896/DDX8046BT only) Connection cable (Included in the Navigation System) Connection cable (Included in the TV tuner)   TO MONITOR UNIT ⁄ Navigation units that can be connected to this unit. English 7  DFPKA$ Installing the GPS Antenna (DNX9960 only) GPS antenna is installed inside of the car. [. . . ] „ Make sure that the unit is installed securely in place. Installation on Toyota, Nissan or Mitsubishi Car using Brackets Accessory 8 (M5x6mm) or Accessory 9 (M5x7mm) Car Bracket Accessory 8 (M5x6mm) or Accessory 9 (M5x7mm) 10 DNX SERIES/ DDX SERIES    DFPKA$ Removing Monitor/Player Unit Removing the Hard Rubber Frame (escutcheon) 1. Engage the catch pins on the removal tool 5 and remove the two locks on the lower level. Remove the hard rubber frame by referring to the removal procedure in the section <Removing the Hard Rubber Frame>. [. . . ]