User manual KENWOOD DDX630W

[. . . ] If the power is not turned ON (or it is ON, but will be OFF immediately), the speaker wire may have a short-circuit or touched the chasis of the vehicle and the protection function may have been activated. If your car's ignition does not have an ACC position, connect the ignition wires to a power source that can be turned on and off with the ignition key. If you connect the ignition wire to a power source with a constant voltage supply, as with battery wires, the battery may die. [. . . ] If you connect the ignition wire to a power source with a constant voltage supply, as with battery wires, the battery may die. If the console has a lid, make sure to install the unit so that the faceplate will not hit the lid when closing and opening. If the fuse blows, first make sure the wires aren't touching to cause a short circuit, then replace the old fuse with one with the same rating. Insulate unconnected wires with vinyl tape or other similar material. To prevent a short circuit, do not remove the caps on the ends of the unconnected wires or the terminals. The unit may be damaged or fail to work if you share the - wires or ground them to any metal part in the car. When only two speakers are being connected to the system, connect the connectors either to both the front output terminals or to both the rear output terminals (do not mix front and rear). For example, if you connect the + connector of the left speaker to a front output terminal, do not connect the connector to a rear output terminal. For that reason, always make sure to turn off the unit's power when the ignition is turned off. to link the unit's power to the ignition , connect the ignition cable (ACC. Red) to a power source that can be turned on and off with the ignition key To TV Tuner unit Do not connect. Engage the catch pins on the removal tool 3 and remove the two locks on the lower level. Remove the Hex-head screw with integral washer (M4 × 8) on the back panel. Insert the two removal tools 3 deeply into the slots on each side, as shown. Lower the removal tool toward the bottom, and pull out the unit halfway while pressing towards the inside. Pull the unit all the way out with your hands, being careful not to drop it. [. . . ] Lower the removal tool toward the bottom, and pull out the unit halfway while pressing towards the inside. Pull the unit all the way out with your hands, being careful not to drop it. To prevent the Remote control unit from dropping down under your foot, install it using the Remote control unit holder. [. . . ]