User manual KAZ V977

[. . . ] With its unique technology, the Forehead Thermometer can provide a stable, heat-interference-free reading with each measurement. The instrument performs a self-test every time it is switched on to always guarantee the accuracy of measurements. The Forehead Thermometer is intended for the monitoring of human body temperature in the home. Please read these instructions carefully before using this instrument and keep the instructions and the thermometer in a safe place. [. . . ] This energy is collected through the lens and converted to a temperature value. Temperature readings obtained by scanning above the eyebrow area will provide the greatest accuracy. The Forehead Thermometer has been clinically tested and proven to be safe and accurate when used in accordance with its operating instruction manual. 5. Control Displays and Symbols LCD Display Display meaning Self check ensures proper functioning Description Press the On/Off button to run on the unit, all segments will be shown for 2 seconds. The last reading will be shown on the display automatically for 3 seconds. The unit is ready for the measurement, the °F icon will keep flashing. The reading will be shown on the LCD display with the °F icon flashing, the unit is ready again for the next measurement. When the unit is turned on, the battery icon will keep flashing to remind the user to replace the batteries. Recall of last reading Ready to measure Measurement complete Low battery indication 6. The last measurement reading will be shown on the display automatically for 3 seconds with the «M» icon. When the °F icon is flashing, a beep sound is heard and the thermometer is ready for the measurement. Place the probe gently and flush onto the area approximately 1/2 inch above the center of the eyebrow. If the eyebrow area is covered with hair, sweat or dirt, please clean the area beforehand to improve the (4) reading accuracy. Start to move the instrument steadily from 1/2 inch above the center of the eyebrow to 1/2 inch above the tail of the eyebrow area and back up again. A long (5) beep will sound after 3 seconds to signal measurement complete. If the probe movement is too slow to reach the tail of the eyebrow before the long beep sound is heard, repeat the measurement as (6) above from step 4, and move the probe a little quicker this time. Read the recorded temperature from the LCD display. To avoid an inaccurate measurement, note the following: · Patients should stay in steady - state room condition for at least 30 minutes. · Don't remove the measurement device from the measuring area before hearing the final beep. · Don't take a measurement while or immediately after nursing a baby. · Don't use the forehead thermometer in high humidity environments. · Patients should not drink, eat, or be physically active before/while taking the measurement. · Before placing the thermometer sensor onto the measurement area, remove dirt, hair, or sweat. · Use an alcohol swab to carefully clean the sensor and wait for 5 minutes before taking a measurement on another patient. [. . . ] Replace the batteries being sure to align properly as indicated inside the battery compartment. Remove the battery from the instrument if it is not required for extended periods of time in order to avoid damage to the thermometer resulting from a leaking battery. Dispose of batteries according to local waste management directions. 11. Warranty Your Forehead Thermometer is durable and manufactured for normal, household use. [. . . ]