User manual KAZ IRT 3020 CO

[. . . ] This thermometer must only be used with genuine Braun ThermoScan Lens Filters. ⷠTo avoid inaccurate measurements always use this thermometer with a new, clean lens filter. ⷠIf the thermometer is accidentally used without a lens filter, clean the lens after use (see «Care and cleaning»). ⷠUse of this thermometer is not intended as a substitute for consultation with your physician. [. . . ] After one second a longer beep will signal the end of the measuring process. For the next measurement, remove the used lens filter and put on a new, clean lens filter. clear the display by pushing the «start» button once. Fit the probe snugly into the ear canal, then push the «start» button. The Braun ThermoScan ear thermometer turns off automatically after 60 seconds of inactivity. A measurement taken in the right ear may differ from the measurement taken in the left ear. ⷠThe ear must be free from obstructions or excess earwax build-up to take an accurate reading. ⷠExternal factors may influence ear temperatures, including when an individual has: ­ been lying on one ear or the other ­ had their ears covered ­ been exposed to very hot or very cold temperatures, or ­ been recently swimming or bathing. In these cases, remove the individual from the situation and wait 20 minutes prior to taking a temperature. ⷠIf ear drops or other ear medications have been placed in the ear canal of one ear, take the temperature in the untreated ear. If the thermometer is accidentally used without a lens filter, clean the probe tip as follows: Very gently wipe the surface with a cotton swab or soft cloth moistened with alcohol. Once the alcohol has dried completely, a new lens filter can be put on and a temperature measurement taken. Use a soft, dry cloth to clean the thermometer display and product exterior. Store the thermometer and lens filters in a dry location free from dust and contamination and away from direct sunlight. Additional lens filters (LF 40) are available at most stores selling Braun ThermoScan. Ambient temperature is not within the allowed operating range (10 ­ 40 °C or 50 ­ 104 °F). Allow the thermometer to remain for 30 minutes in a room where the temperature is between 10 and 40 °C or 50 and 104 °F. Make sure the probe tip HI = too high and lens are clean and a new, clean lens filter is attached. [. . . ] The first number after LOT represents the last digit of the year of manufacture. An example: LOT 503 ­ this product has been manufactured in the week 03 of the year 2005. If device is not used within specified temperature and humidity ranges the technical accuracy can not be ensured. This appliance conforms to the following standards: DIN EN 60601-1: 3/96 «Medical electrical equipment» ­ Part 1: General requirements for safety DIN EN 12470-5: 2003 «Clinical thermometers» ­ Part 5: Performance of infrared ear thermometers (with maximum device) This product conforms to the provisions of the EC directive 93/42/EEC (Medical Device Directive). [. . . ]