User manual KAZ BP 3560

[. . . ] Example: If the monitor is positioned 20 cm below heart level as shown on the left (e. By putting the arm on a table), the reading you will obtain is approximately 15 mmHg too high. Therefore, the Braun SensorControl has an active positioning system (A): it guides you to hold your measuring arm in the right position at heart level and gives you confirmation of correct handling after the measurement. Additionally, your blood pressure monitor features an EasyClick cuff which automatically fastens correctly to your wrist to ensure an accurate fit for an accurate reading. [. . . ] When the measurement is complete, a beep will sound again, and the reading is displayed along with the feedback from the confirmation system (B): Upper (systolic) value Lower (diastolic) value Pulse Confirmation system (B) The green dot in the lower left corner of the display confirms that the measurement conditions have been okay. If not okay, a red dot is flashing and the positioning system (flashing arm) shows the reason for the measuring error: Measuring arm: too low . In case of system errors or handling mistakes, the display will show an error code, instead of giving you inaccurate results (for details, please see section «What to do if. 15 seconds after switching on the appliance, the measuring process will start automatically, even if the appropriate measuring position has not been reached. Your blood pressure monitor can store the readings of 100 measurements (BP 3550 model: 80 measurements). This means that you will not loose stored data when changing batteries. Recalling stored readings To recall stored readings, first turn the product off, then press the memory button (E). The lower display line successively shows memory index and pulse on the one hand and date and time of the respective measurement on the other hand. The memory reading also includes the feedback from the confirmation system as described above. Repeatedly pressing the memory button (E) will call up one by one all stored readings: m (­) towards older readings n (+) towards younger readings Scrolling Keep one side of the memory button pressed for scrolling through the memory. Push the select button (D) for longer than 3 seconds to enter the select mode. Press the select button again to make the month position flash, adjust it using the memory button. Press the select button again and proceed the same way to adjust the time (hour/minute). After having changed date and time, press the on/off button (C) to confirm. Because you want to measure while lying down), proceed as follows: Turn off the product. Push the select button (D) for longer than 3 seconds and wait for the confirmation beep. Then repeatedly press the select button until the positioning system symbol ( ) will be displayed next to a flashing «ON». Press one side of the memory button to change the setting from «ON» (positioning system activated) to «OFF» (positioning system deactivated). Please note: Unless you confirm a modified setting by pressing the on/off button, the appliance will turn off automatically after 2 minutes without adapting the modified setting. If used according to the use instructions, periodic re-calibration is not required. If at any time, you question the measuring accuracy, please contact a Braun Service Centre. Manufacturing date is given by the LOT number on the back of the product. [. . . ] L'aide à distance (I) vous aide à conserver la distance requise d'environ 2 cm au-dessus de la ligne de paume. For a reliable blood pressure measurement, please follow the instructions below. Place the monitor housing on the slim side of your bare forearm with the monitor facing up. The distance aid helps you to keep the required 2 cm distance to your palm line. [. . . ]