User manual JRC NSVS1061

[. . . ] 2005 JRC SAW FILTER NSVS1061 Application 174MHz GPS Electrical Specification: (Table 1) The device characteristics are measured in the circuit shown in Fig. 1. Input and Output Impedance 50 Nominal Center Frequency (f0) 174 MHz 3dB Bandwidth 22 MHz Insertion Loss 163. 0~185. 0MHz 12. 0 dB 10. 0 dB Response Variation 163. 0~185. 0MHz 1. 5 dB 1. 0 dB Group Delay Variation 163. 0~185. 0MHz 150 ns 100 ns Out of Band Rejection 149~157MHz 30 dB 40 dB 191~199MHz 30 dB 30 dB (Operating Temperature Range: -20~+70ºC) Maximum Rating: (Table 2) Table2. [. . . ] 1 2 3 4 5 6 7 8 9 10 Connection GND(PKG) GND(PKG) GND(PKG) OUT/IN GND(signal) GND(PKG) GND(PKG) GND(PKG) IN/OUT GND(signal) (R0. 2) [10· ~ ] Fig. 2 Package dimensions(in mm) NSVS1061 Jan. It might not be satisfied with electrical specification without operating temperature range. When it is used less than -20ºC or more than +70ºC, it might be a cause of degradation or destruction of the component. Even if it endures during a short time, it causes degradation of qualification. When soldering iron is used, solder with the temperature at the tip of soldering iron: 350ºC max. , the time of soldering: 10 seconds max. , the power of soldering iron: 30W max. . Notice that the allowed time of soldering with soldering iron is accumulated time, when soldering is repeated. As rapid temperature change for cleaning after reflow soldering might be a cause of destruction clean this component after confirming that temperature of this component goes down to room temperature. Confirm that there are not any influence for qualification to this component in mounting on PCB when this component is cleaned. As it might be a cause of degradation of destruction to apply static electricity to this component, do not apply static electricity or excessive voltage while assembling and measuring. This specification specifies the quality of this component as a single unit. [. . . ] When intending to use any our product please contact our sales representatives in advance. 3. NSVS1061 Jan. 2005 FREQUENCY CHARACTERISTICS 10 Insertion Loss [dB] 6 8 10 12 14 16 154 164 174 184 194 Frequency [MHz] 20 30 40 50 60 1000 G roup Delay [ns] 900 800 700 600 500 162 168 174 180 186 Frequency [MHz] S11 S22 [. . . ]