User manual JONSERED LT 2213

[. . . ] Such instruction should emphasize: - the need for care and concentration when working with ride-on machines; - control of a ride-on machine sliding on a slope will not be regained by the application of the brake. The main reasons for loss of control are: a) insufficient wheel grip; b) being driven too fast; c) inadequate braking; d) the type of machine is unsuitable for its task; e) lack of awareness of the effect of ground conditions, especially slopes; f) incorrect hitching and load distribution. Do not operate the engine in a confined space where dangerous carbon monoxide fumes can collect. Before attempting to start the engine, disengage all blade attachment clutches and shift into neutral. [. . . ] Place seat on seat pan so pads are positioned over large slotted hole in pan (2). Push down on seat to engage pads in slots and pull seat towards rear of tractor. Lift up adjustment lever (4) and slide seat until a comfortable position is reached which allows you to press clutch/brake pedal all the way down. Check that the flex is correctly connected to the safety switch (3) on the seat holder. Batterie Install battery NOTE: If battery is put into service after month and year indicated on label, charge battery for minimum of one hour at 6-10 amps. WARNING: Before installing battery remove metal bracelets, wrist watch bands, rings, etc. WARNING: Positive terminal must be connected first to prevent sparks from accidental grounding. The throttle control regulates the engine revs and thus the rotation speed of the blades. = Full speed = Idling speed Used for declutching and braking the tractor and starting the engine. When the engine is cold the choke should be pulled out before starting. When the engine has started and is running smoothly push the choke in. Turning the ROS "ON", to allow reverse operation with the attachment clutch engaged, should only be done when the operator decides it is necessary to reposition the machine with the attachment engaged. With engine running, turn ignition key counterclockwise to ROS "ON" position. â· Move gear shift lever to reverse (R) position and slowly release clutch/brake pedal to start movement. â· When use of the ROS is no longer needed, turn the ignition key clockwise to engine "ON" position. Clear the lawn from stones and other objects which can be thrown away by the blades. Begin with a high cutting height and reduce until the required cutting result is obtained. The cutting result is best with high engine speed (blades rotate quickly) and low gear (machine goes slowly). If the grass is not too long and thick the drive speed can be increased by selecting a higher gear or reducing the motor speed, without affecting the cutting result. Cutting becomes more even and the cut grass is more evenly distributed over the surface. Total time taken is not greater, since higher drive speed can be selected without affecting the cutting results. The cutting results will be worse since the wheels will sink into the soft lawn. [. . . ] Remove belt from clutch pulley (M), both mandrel pulleys (R) and all idler pulleys (S). Install belt around both mandrel pulleys (R) and around idler pulleys (S) as shown. If tires are over or under inflated, it may affect the appearance of your lawn and lead you to think the mower is not adjusted properly. With all tires properly inflated and if your lawn appears unevenly cut, determine which side of mower is cutting lower. [. . . ]