User manual IRRITROL JUNIOR MAX

[. . . ] A short circuit in the field wiring or the valve solenoid will cause the automatic circuit breaker open and stop electrical output. This sequence will continue until the program advances to the next station. To verify that there is a short circuit problem, go to the manual mode and start the station. If it doesn't start or turns off before the set run time, troubleshoot the field wiring and valve solenoid. Power failure indication During a power failure the "24V" will start flashing, if a 9 volt battery is connected. [. . . ] Press to advance to next station. To RESET Run Time back to "OFF": Press BOTH +/ON and -/OFF for a few seconds until OFF is displayed. To disable the MASTER VALVE from working in this program: Press until "M" starts flashing. The display show "On". Press -/OFF to disable the MASTER VALVE. Press NEXT to advance to WATER DAYS 6 Program position: WATER DAYS Calendar Prog. A There are 4 choices for your days selection: CAL - Select days of the week. (Default all days are ON) Int - Select days interval, 1-7 days, and the 1st day to start the interval Odd - Irrigation on Odd days (31st day is skipped) En - Irrigation on Even days. In CAL position: Press +/ON for operating day or -/OFF to skip the day. Press for Interval selection or NEXT for next programming step. In "Int" position: Press +/ON or -/OFF to select your days interval. Press to select the 1st day to start the watering using +/ON or -/OFF. if you wish to go back to CALENDAR. In Odd position: Press In Even position: Press NOTE: 31st day of month is skipped in ODD water days. Press NEXT to advance to START TIMES. Program position: START TIMES 3 start times per day are available for each program. Press for start #2 and #3 and repeat with +/ON or -/OFF to set the time. To RESET Start Time back to "OFF": Press BOTH +/ON and -/OFF for a few seconds until OFF is displayed. After setting start times, you can Press PROG to start entering data for the next program. The program position will automatically move back to the RUN TIME position of the next program. If you press NEXT you advance to the "% Scaling" position. 7 Program position: % SCALING (Seasonal adjust) In this program position, you can increase or decrease the RUN TIMES of all stations in a program by percentage scaling from 0% (program OFF) to 200% in 10% increments. Press +/ON or -/OFF to change adjustment from 100% The initial RUN TIME set represents 100%. The new adjusted run time will be displayed whenever the program is operating. The "%" icon will also be displayed whenever that program is operating or being reviewed to alert you that the run time has been adjusted from the initial setting. To set a program to "OFF" If you wish to stop irrigation of a program, set percentage scaling to 0%. To resume normal operation of that program, advance to "% SCALING" and increase the percentage to your desired value. Press NEXT to advance to MANUAL. Program position: MANUAL In this MANUAL mode, you can set RUN TIME for each of the stations you wish to start manually. Press to advance to next station. To turn ON the 1st station in the sequence: Press NEXT to AUTO-RUN position. Operating stations will flash and the display will show the remaining RUN TIME of the station (count down). [. . . ] Using the second and third start times changes program C to a looping program. A looping program allows the stations assigned to program C to be run repeatedly throughout a 24 hour period. A loop program is desirable for seed germination, asexual propagation, misting and cooling. Sensors such as thermostats, humidity sensors, etc. , can be incorporated into the looping program. [. . . ]