User manual HYUNDAI HYM43SP

[. . . ] The operator of the machine is responsible for, and has a duty of care in making sure that the machine is operated safely and in accordance with the instructions in this user manual. Keep the manual safe and pass it on if the machine is loaned or sold to another user. The machine should never be left it in a condition which would allow an untrained or unauthorised person/s to operate this machine. Should be taken by the operator for the safety Of, and with regard to, those around whilst Some or all of the following - May appear throughout this manual. [. . . ] Once the correct amount of oil has been added replace the dipstick making sure that it is secure. Please note there may be some residual oil in the engine this is normal. F you have put too much oil into the engine you can remove some by removing dipstick, tilting machine and poor out excess oil. Please note you must place a suitable container under drain plug to catch excess oil. Fill the fuel tank with fresh straight unleaded petrol ­ Allow a 25mm gap from the top of the tank. You must only use straight, fresh unleaded petrol ­ DO NOT mix petrol with oil. Before use you MUST check and if necessary adjust the OPC control cable, if it is too loose the the lawnmower will not start. To locate the adjuster follow the cable from the OPC handle to the engine body where you will see the OPC adjuster. Start by undoing the lock nut (anticlockwise) then turn the adjuster nut in a clockwise direction. Attempt a start if adjusted correctly the lawnmower will start once started you must tighten the locknut, continue to adjust until lawnmower starts. Some models have a cover over the adjuster remove to adjust and replace once task is completed. Mulching plug HYM46SP only ­ In mulching mode you must remove the grass catcher. Push the mulching plug (wedge) into the discharge channel and lock it into the slot. Cut & Drop/Side discharge HYM46SP only - In Cut & Drop/Side discharge mode you must remove the grass catcher. For grass collection mode you must remove the mulching plug and side discharge chute. Make sure the blade is free of long grass and the cutting height set to maximum. Pull back the Operator Presence Control (OPC) lever towards the main handle. Pull the recoil starter handle swiftly ­ repeat until engine starts. Before stopping the machine allow the engine to cool down for a few minutes. You MUST allow the blades to come to a full stop before carrying out any maintenance on the machine. To STOP the machine release the Operator Presence Control (OPC) lever and allow it to move away from the main handle. Always use the lawnmower with the grass catcher, or rear deflector in position. [. . . ] If the starter rope becomes disconnected from the rope guide on handle, disconnect the spark plug cap. Depress the blade control handle and pull the starter rope out from engine slowly and re- engage in guide. Throttle lever not in the correct position for the prevailing conditions. Remove air filter element and pull starter rope continuously until carburetor clears. [. . . ]