User manual HUNTER 37125

[. . . ] Refer to and follow the CLEANING AND FILTER REPLACEMENT instructions. Introduction Thank you for purchasing the HEPAtechTM Air Purification System from Hunter Fan Company. You have purchased our latest development in portable Air Purification Systems. This system has been developed to improve the quality of the air you breathe. Our HEPAtechTM Air Purification System out performs other air purification systems by quickly and effectively removing dust, smoke, and pollen particles as small as . 1 microns in size. [. . . ] Check Filter: When the check filter light is illuminated, you should open the front grill and compare the filter to the check filter chart. Use the tip of a pen or pencil to press the reset button. AIR PURIFIER PARTS FIGURE 1 FRONT GRILL FRONT GRILL OPENS FROM BOTTOM Models 30110, 30125, 37125, 30140 and 30165 all open in the same manner. FORM 41304-01 3 ©1999 HUNTER FAN CO. Using Your Air Purifier 1. Remove your air purifier from the box and take it out of the clear plastic protective bag. Place your HEPAtechTM Air Purification System on a firm, flat surface. Before turning the Air Purifier `on', you need to open the front grill and remove any protective plastic that may be surrounding the HEPAtechTM filter. Release the front grill by pulling the grill forward near the bottom of the unit. When you replace the filter in the unit, the white filter material should be facing outward (towards you) and the black carbon material should be hidden from view (inside the unit). Locate the top tabs in the unit first, and then push the bottom of the grill into the unit until it is closed. NOTE: The unit will not operate unless the door is placed in the correct position. Plug the unit into a 120V electrical outlet. Cleaning And Filter Replacement (Models 30110, 30125, 37125, 30140 and 30165 use Replacement Filter 30925) 1. Be sure that all parts are completely dry before you reassemble them to the Air Purifier. When you remove the front grill to clean it, you should also remove the pre-filter from the front grill and gently wash it in soapy water. Washing the pre-filter can help extend the life of your HEPAtechTM Filter. Every few weeks, you should open the front grill and view the condition of the HEPAtechTM Filter. Compare the filter to the color coded chart that is on the inside of the housing. If the filter matches the dark color on the chart, you should remove the filter and replace it with a new filter. Be sure to remove any plastic wrapping that may be on the new filter before you place it into the Air Purifier. Mounting the Air Purifier to the Wall Your air purifier has keyhole slots on the back which can be used to mount your air purifier to the wall. To mount your air purifier to the wall, use plastic dry wall type anchors #14-16 and 1/4" lag screws 11/2" long, or equivalent. Optimum performance will be achieved when the unit is placed on the floor, 6 inches away from the walls. Replacement Filters: To obtain a replacement filter for your Air Purifier, call customer service at 901-248-2222 or e-mail us at TechSupport@hunterfanhq. com. Please be prepared to tell the operator the model number of your Air Purifier and the model number of the filter you need to replace. [. . . ] There are no express or implied warranties as to commercial purchasers or users. To obtain service, contact the nearest Hunter authorized service centre or the Hunter Fan Company Service Department, 2500 Frisco Avenue, Memphis, Tennessee 38114, 901-248-2222. For the name of our nearest authorized Hunter Fan Company Service Centre, write to the Hunter Fan Company at the preceding address. You will be responsible for insurance and freight or other transportation to our factory service center. [. . . ]