User manual HP PHOTOSMART 612

[. . . ] hp photosmart 612 digital camera user guide hp photosmart 612 digital camera user guide Trademark and copyright information © Copyright 2001 Hewlett-Packard Company All rights are reserved. No part of this document may be photocopied, reproduced, or translated to another language without the prior written consent of Hewlett-Packard Company. The information contained in this document is subject to change without notice. Hewlett-Packard shall not be liable for errors contained herein or for consequential damages in connection with the furnishing, performance, or use of this material. [. . . ] You can delete unwanted images from the camera anytime, making space available for new images. However, your camera also has a slot for digital "film" in the form of a CompactFlash (CF) memory card (purchased separately). The card is more economical than conventional film because you can reuse the card over and over again. If you install a CF memory card in your camera, images are stored on the CF memory card rather than in the camera's internal memory. Note If your computer runs Windows NT or if it does not have a USB port, you must store images on a CF memory card. Then use a CF memory card reader to transfer images to your computer. This chapter describes how to use your camera with or without a CF memory card and how to copy images from internal memory to a CF memory card. Tip As long as you have a CF memory card in the camera, you can gain access to only the images stored on the CF memory card. For more information, see "Using both internal memory and a CF memory card" on page 42. Storing images in memory 37 Determining the number of pictures you can take You can store as many as 113 images in the camera's internal memory. The number of pictures that you can take and store in the space remaining in memory depends on several factors. Unlike conventional film, each digital image takes up a different amount of space in memory. Images that are complex and contain many details take up more space, whereas simple images take up less space. Pictures taken full size occupy more space, whereas pictures taken with digital zoom occupy less space. However, the most important factor in image size is the image quality you have selected. The number of images remaining in memory is indicated in the status LCD on top of the camera. As you change the settings, the number of remaining images that is indicated on the status LCD changes. The number of images you can store in the camera depends primarily on image quality: Pictures taken with an image quality of BEST (three stars) require the most memory. Pictures taken with an image quality of BETTER (two stars) require less memory. Pictures taken with an image quality of GOOD (one star) require the least amount of memory. You can store a maximum of approximately 113 such images on the camera. number of images remaining in memory 38 HP photosmart 612 User Guide If internal memory is full, "0" appears for the remaining picture count and a red light appears to the left of the viewfinder when you press the SHUTTER button. In addition, if the image display is on, the message MEMORY FULL appears in the status line. To resume taking pictures, unload images to your computer and delete them from the camera, or install a CF memory card. Note The HP photosmart 612 digital camera is shipped without a CF memory card. If you do not install a CF memory card, all images are automatically stored in internal memory. Using a CF memory card If you install a CF memory card, all images taken after installing the CF memory card are saved to the card. [. . . ] TO THE EXTENT ALLOWED BY LOCAL LAW, THE REMEDIES IN THIS WARRANTY STATEMENT ARE YOUR SOLE AND EXCLUSIVE REMEDIES. Troubleshooting 63 9 EXCEPT AS INDICATED ABOVE, IN NO EVENT WILL HP OR ITS SUPPLIERS BE LIABLE FOR LOSS OF DATA OR FOR DIRECT, SPECIAL, INCIDENTAL, CONSEQUENTIAL (INCLUDING LOST PROFIT OR DATA), OR OTHER DAMAGE, WHETHER BASED IN CONTRACT, TORT, OR OTHERWISE. Some countries, states or provinces do not allow the exclusion or limitation of incidental or consequential damages, so the above limitation or exclusion may not apply to you. THE WARRANTY TERMS CONTAINED IN THIS STATEMENT, EXCEPT TO THE EXTENT LAWFULLY PERMITTED, DO NOT EXCLUDE, RESTRICT OR MODIFY AND ARE IN ADDITION TO THE MANDATORY STATUTORY RIGHTS APPLICABLE TO THE SALE OF THIS PRODUCT TO YOU. Hardware repair services If you think your camera, ADF, or XPA needs repair, first call the Customer Support Center, which can help determine if service is required and direct you to a service site. For more information, see "Contacting HP Customer Support" on page 59. [. . . ]