User manual HOLMES HASF1650

[. . . ] JCS shall not be liable for any incidental or consequential damages caused by the breach of any express, implied or statutory warranty or condition. Except to the extent prohibited by applicable law, any implied warranty or condition of merchantability or fitness for a particular purpose is limited in duration to the duration of the above warranty. JCS disclaims all other warranties, conditions or representations, express, implied, statutory or otherwise. JCS shall not be liable for any damages of any kind resulting from the purchase, use or misuse of, or inability to use the product including incidental, special, consequential or similar damages or loss of profits, or for any breach of contract, fundamental or otherwise, or for any claim brought against purchaser by any other party. [. . . ] Do not operate any appliance with a damaged cord or plug after the appliance malfunctions, or has been dropped/damaged in any manner. The use of attachments not recommended or sold by the appliance manufacturer may cause hazards. Do not let the cord hang over the edge of a table, counter or come in contact with hot surfaces or leave exposed to high traffic areas. Do not operate fan until fully assembled with all parts properly in place. This product is intended for household use ONLY and not for commercial or industrial applications. WARNING: To reduce the risk of fire or electric shock, DO NOT use this fan with any solid-state speed control device. F E AT U R E S - O P E R AT I O N S Figure 1 A ® F E AT U R E S - O P E R AT I O N S CLEANING/MAINTENANCE OPERATING INSTRUCTIONS Your fan is UL approved and safe to be used Indoors or Outdoors. Outdoor applications provide a cool, refreshing breeze on hot stagnant days as well as warding off annoying insects or barbecue smoke. Selector (Speed) Control is located at the rear of the Fan Motor Housing. The SPEED is adjusted by turning the control knob to the desired setting, OFF-III-II-I. The Oscillation Control Knob is located on the top of the Fan Motor Housing. To Stop Oscillation, pull control knob up. B C D E F G Figure 2 H CLEANING/MAINTENANCE INSTRUCTIONS Follow these instructions to correctly and safely care for your fan. Please remember: · Always unplug the fan before cleaning or disassembling. · Do not use any of the following as a cleaner: gasoline, thinner, benzene. Replace blade, tighten securing screw and securely fasten the front grill. Fan Head, Base and Pole Cleaning Using a soft, moist cloth, with or without a mild soap solution, carefully clean the fan base, pole and head. Do not allow the motor or other electrical components to be exposed to water. PLEASE READ AND SAVE THESE IMPORTANT SAFETY INSTRUCTIONS ASSEMBLY INSTRUCTIONS NOTE: MAKE SURE YOU REMOVE ALL CONTENTS OF THE PACKAGE. PLEASE CHECK PACKAGING MATERIALS FOR PARTS THAT COULD BE REQUIRED TO ASSEMBLE YOUR FAN. Base/Pole Assembly You will need the base, Round Weight, pole assembly, pole ring, washer and L-shaped locking lever (See Figure 1-2). Turn the base upside down and place the weighted insert and washer into the base cover. Secure the base and round weight to the bottom of the outer pole using the L-shaped locking lever and washer. Turn the L-shaped locking lever clockwise to securely attach the pole to the base. Fan Head Assembly You are now ready to assemble the fan head (See Figure 1-2). [. . . ] First slide the inner pole extension up from the outer Secure the rear grill in its place using the rear grill pole. Turn this nut clockwise and tighten outer pole to securely hold this position. fan head assembly into this extension pole, inserting the Slide the fan blade, with the hollowed interior of the neck of the fan into the pole opening. Turn the fan blade facing toward the rear grill, firmly onto the head's neck until the head is securely locked into place. [. . . ]