User manual HELIX DXP-6 COMPETITION

[. . . ] We wish you many hours of enjoyment with your new digital HELIX crossover. Yours AUDIOTEC FISCHER Team General installation instructions for HELIX-components To find out how digital HELIX crossover works best for you, read this manual carefully and follow the instructions for installation. We guarantee that this product has been checked for proper functioning before shipping. [. . . ] Never lay the power supply cables adjacent to leads and lines connecting other vehicle equipment (fan motors, fire detection modules, gas lines etc. In order to ensure safe installation, use only high-quality connections and materials. Thus, the HELIX DXP-6 can be connected to the pre-amlifier-output of the head-unit by using Cinch-plugs. 1 Power Connector: Ground Cable The Ground Cable should be connected to a to a dismantled, unlaquered ground point of the car chassis. Thus, the HELIX DXP-6 is switched on and off automatically togehter with the head-unit. If this is neglected, static noise can occur when the amplifiers are switched on or off. 1 Selection of the Input-Source Using the SOURCE-key, either the analog or the digital input mode can be chosen. 2 Adjustment of the Bass Level Using the keys UP and DOWN the Bass Level can be adjusted in 2-dB-steps from 0 to 18 dB. The respective Output-Channel can be chosen via the keys CH+ und CH­. 1Setup Mode The following adjustments can carried out in the Setup-Mode: - INPUT LEVEL SETUP (only analog) - CHANNEL SETUP - BASS EQ SETUP 8. 1 Input Level Setup Using the key INPUT LEVEL the respective menu can be chosen. 1Control Unit Via the Control Unit the Digital Crossover HELIX DXP-6 can be operated in three different control modes: - NORMAL MODE - SETUP MODE - TEST TONE MODE The respective channel has to be chosen with the keys MENU+ und MENU­. 2 Channel-Setup By using the the CHANNEL key, the respective menu can be selected. The output channels which have to be adjusted can be selected via the keys CH+ and CH­. Please chose the desired function for each channel with the keys MENU+ and MENU­. the menu DELAY TIME provides the possibility to change the displayed unit. 3 Test Tone Mode The HELIX DXP-6 has a Test-Tone-Mode (white noise) in order to test the loudspeaker connections and the balance settings of each channel. The channel which shall be tested can be selected via the keys CH+ and CH­. [. . . ] Should it be necessary to return the product to the factory, please ensure that a) the product is packed in original factory packing in good condition b) the warranty card has been filled out and attached to the product c) the product is shipped prepaid, i. At your expense and risk d) the receipt/invoice as proof of purchase is enclosed 5) Excluded from the warranty are: a) Shipping damages, either readily apparent or concealed (claims for such damages must be immediately notified to the forwarding agent). c) Defects d) Products caused which by incorrect been installation repaired or connecor tion , by operation errors , by overloading or by external force. [. . . ]