User manual HAWKING HPS3P

[. . . ] FCC Warning This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to subpart J of Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a commercial environment. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instruction manual, may cause harmful interference to radio communications. Operation of this equipment in a residential area is likely to cause harmful interference in which the user will be required to correct the interference at their own expense. [. . . ] Select Printer 0 (or Printer 1, Printer 2), and press Enter, then select Parallel LPT1 (or LPT2, LPT3) in the Type field. If your print server has only one port, you do not need to configure this Type field. 21. Select Queues Serviced by Printer, then select Printer 0 (or Printer 1, Printer 2) and press Enter. Press Insert and add your newly created print queue to the list of queues serviced by the printer. Enter a priority number for the queue service, or press Enter to accept the default. 24. Repeatedly press Escape to exit the PCONSOLE program. 25. Reset the print server to have the changes take effect. NOTE: If the print server you have is with multiple printer connectors, you may create multiple print queues and printer objects. You should be able to redirect printing to your print server using a CAPTURE command like the one shown in the previous section. 5. 2. 2. 2 Configuring as a Remote Printer Mode The remote printer feature is not available for some print server models. Make sure that you have created the NetWare print server with Type Remote using PCONSOLE utility before you configure the print server. For more detailed information about PCONSOLE, please refer to NetWare's manual. You can set up the NetWare print server and print queue objects by following the steps below: 1. Change the current file server, if necessary, using the Change Current File Server menu selection. Type in a print queue name, like "PQ" or "Q1". 6. You have now successfully created the print queue that your NetWare print server will serve. Press the Escape key until the Available Options main menu is displayed. Select "Print Server Configuration. " Select "Printer Configuration. " 12. Select Printer 0 (or Printer 1, Printer 2), press Enter, and then select Remote Parallel in the Type field. 13. Select Queues Serviced by Printer, then select Printer 0 and press Enter. 15. Press Insert and add your newly created print queue to the list of queues serviced by the printer. Enter a priority number for the queue service, or press Enter to accept the default. 16. You must now load the NetWare print server on the NetWare file server so that the print server configured as a remote printer can connect to that print server and service the print jobs. To load the NetWare print server, type "LOAD PSERVER. NLM PrintServer" at the system console of the NetWare file server where the PrintServer is the print server name newly created by the PCONSOLE program. To configure the print server as a NetWare remote printer, perform the following steps: 1. [. . . ] The client side must install and setup the TCP/IP protocol for an active Internet connection. 9. 3 9. 3. 1 System Setup Print Server Side Step1. Execute the Print Server Configuration Utility. Step3. In the Mail Print Cfg page configure Mail polling time and MailBox parameters. Mail Polling Time: Default is 1 minute; Intervals for print server to check Emails in the MailBox. Mail Server - Mail Account and Password are the Mailbox's Email server's IP address, account, and password respectively. [. . . ]