User manual HAWKING HKS104 DOCUMENT

[. . . ] FCC Warning This equipment has been tested and found to comply with the regulations for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a commercial environment. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with this user's guide, may cause harmful interference to radio communications. [. . . ] The HKS104 KVM Switch is a 4-port PS/2 type KVM Switch that provides compact and integrated all-in-one KVM connectors on the Switch side. It enables users to access, control, boot and reboot multiple computers using only one keyboard, monitor, and mouse. Furthermore, the 3-in-1 KVM cable is tailor-made to integrate keyboard, monitor, and mouse interfaces all into one connector, thus saving a lot of unnecessary time and effort. The HKS104 is an excellent tool for the management of 4 computers on either SOHO or corporate desktop, making it an ideal SOHO solution. It also eliminates the inconvenience and unnecessary effort involved in constantly moving around from one PC to another. Package Contents: One HKS104 4-port KVM Switch Two Sets of 3-in-1 KVM cables One Quick Installation Guide Check to make sure that the unit was not damaged during shipping. Please read this manual thoroughly, and follow the installation and operation procedures carefully to prevent any damage to the HKS104 unit, and/or any of the devices connected to it. Pre-installation: Note: The default setting for the HKS104 4-port KVM Switch works with most systems. It is a plug and play device: First, connect the shared keyboard, video, and mouse to your KVM Switch and then connect PCs to your KVM Switch using the 3-in-1 KVM cable. Then, boot up your PCs one by one, and you can start to operate the KVM Switch immediately!For a quick start on installation and operation, please follow the instructions below. The correct setup sequence is: (1) Connect the shared keyboard, mouse and monitor to the KVM Switch and then connect the KVM Switch to the computers using the slim 3-in-1 KVM cable (with integrated all-in-one connector on Switch side). Since the KVM Switch receives power from the computer's PS/2 interface, it is powered up when you connect the KVM cables to a PC. (2) To set up your HKS104, please follow the steps below: Before connecting any cable to your KVM Switch, please make sure all of your computers and their peripherals have been powered off. Otherwise, the KVM Switch might not be set up properly. Step 1 - Make sure all the computers that are to be connected to the KVM Switch and their peripherals are in the powered-off state. If not, turn the power off before you proceed with the following steps. Step 2 - Connect the shared keyboard, monitor and mouse to the corresponding connectors on the rear of your KVM switch. Step 3 - Connect each of your computers to the KVM Switch using the 3-in-1 KVM cable. [. . . ] -Description Select a PC Select the active channel Next lower channel Select the next lower connected channel Select the next higher connected channel Toggle on/off the beep sound for switching confirmation while autoscanning Reset the KVM Switch for switch system reboot. Autoscan through every connected channel for quick screen browsing of each channel. Terminate Autoscan activity Next higher channel -- Autoscan Beep Sound On/Off -- Reset KVM -- Autoscan -- Stop Autoscan -- Notes: The (x) denotes a number key for the selected port number (x= 1 ~ 4). [. . . ]