User manual HAWKING HKS102 DOCUMENT

[. . . ] FCC Warning This equipment has been tested and found to comply with the regulations for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a commercial environment. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with this user's guide, may cause harmful interference to radio communications. [. . . ] All brand names and trademarks are the registered property of their respective owners. -1- Introduction The HKS102 Mini 2-Port KVM Switch is a 2-port PS/2 type KVM Switch that has 1. 5M built-in cables. It is a control unit that allows access to multiple computers from a single console (keyboard, monitor and mouse). With the 1. 5M built-in cables, it reduces the cabling troubles and enables users to access, control, boot and reboot two computers using only one keyboard, video and mouse. By allowing a single console to manage all the attached PCs, the HKS102 eliminates the expense of purchasing a separate keyboard, monitor, and mouse for each PC, and saves all the extra space as well. It also eliminates the inconvenience and unnecessary effort involved in constantly moving around from one PC to another. Package Contents: One HKS102 2-port Mini KVM Switch Two Integrated KVM Cables (attached to the KVM Switch) One Quick Installation Guide Check to make sure that the unit was not damaged during shipping. Please read this manual thoroughly, and follow the installation and operation procedures carefully to prevent any damage to the HKS102 unit, and/or any of the devices connected to it. Pre-installation: Note: The default setting for the HKS102 Mini 2-port KVM Switch works with most systems. It is a plug and play device: Just connect the keyboard, the monitor, and the mouse to the KVM Switch. Finally, boot up the computer one at a time and you can start switching between the two computers. For a quick start on installation and operation, please follow the instructions below. Connect the shared keyboard, monitor, and mouse to the KVM Switch first, and then connect one set of built-in cable to the computers. Since the KVM Switch receives power from the computer's PS/2 interface, it is powered up when you connect the KVM cables to a PC. To set up your HKS102, please follow the steps below: Before connecting any cable to your KVM Switch, please make sure all of your computers and their peripherals have been powered off. Otherwise, the KVM Switch might not be set up properly. Step 1: Make sure all the computers that are to be connected to the KVM Switch and their peripherals are in powered-off state. If not, turn the power off before you proceed with the following steps. [. . . ] Hotkey sequence = ScrLk + ScrLk + Command key The two consecutive ScrLk keystrokes should be pressed within 2 seconds and the following command key(s) should also be pressed within 2 seconds in likewise manner. For detailed Hotkey sequences and their corresponding functions, please refer to the Quick reference sheet. QUICK REFERNCE SHEET for the HKS102 Mini KVM Switch Operation Commands Hotkeys/Push Button Push Button -Description Select the active channel Select the next lower connected channel Select the next higher connected channel Toggle on/off the beep sound for switching confirmation while autoscanning Reset the KVM Switch Autoscan through every connected channel for quick screen browsing of each channel. Terminate Autoscan activity Command Select a PC Next lower channel Next higher channel Hotkeys ScrLk + ScrLk + (x)1 (channel no. ) ScrLk + ScrLk + (arrow up) ScrLk + ScrLk + (arrow down) -Press the push button to rotate through to the channel Autoscan Beep Sound On/Off ScrLk + ScrLk +B -- Reset KVM ScrLk + ScrLk + End -- Autoscan ScrLk + ScrLk +S -- Stop Autoscan Any key on the keyboard -- Notes: 1 Note that x denotes a number key for the selected port number. [. . . ]