User manual HAWKING HCF30W DOCUMENT

[. . . ] This equipment generates, uses and can radiate radio frequency energy, and if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning off and on, the user is encouraged to try to correct the interference by one or more of the following measures: Reorient or relocate the receiving antenna. Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. CAUTION: 1) To comply with FCC RF exposure compliance requirements, a separation distance of at least 20 cm must be maintained between the antenna of this device and all persons. [. . . ] When you have finished entering settings, click OK. If you forget to click OK, your settings will not take effect!A message as below may appear saying you must remove and re-insert the Wireless CompactFlash Card to have the changes take affect. Click OK. -9- After installing the H-CF30W Wireless CompactFlash Card's driver successfully, go to Start Programs. Click on PRISM Settings, the Network Status icon will appear in the task bar. - 10 - Network Status Icon & Icon Menu The Status Icon Icon Link Status Green indicates a strong link. Red indicates no or a very poor link. Icon Menu After clicking on the icon, the icon menu as displayed below will prompt you to configure the H-CF30W Wireless CompactFlash Card. - 11 - Items Wireless Radio On Wireless Radio Off Description These two items allow you to enable or disable the wireless radio. Clicking these items will Wireless Network launch the Wireless Status Settings window, as Advanced described below. Version Information. . . All settings are categorized into 5 tabs: Link Configuration Encryption Site Survey About Link The Link tab displays the status of the H-CF30W. - 12 - Item State Description It displays the connection state of the Wireless CompactFlash Card with the wireless network. (There are Channel 14 channels available, depends on the country. ) Click this button to enable/disable Enable Radio the wireless radio. The Wireless / Disable Radio CompactFlash Card will connect/disconnect with the wireless network. It displays the transferring (Tx) Throughput and receiving (Rx) data rate in bytes per second. - 13 - Description It displays the link quality of the Link Quality connection between the Wireless CompactFlash Card and the Access Point or Peer-to-Peer type it connects. Signal Strength It displays the signal strength of the connection between the Wireless CompactFlash Card and the Access Point or Peer-to-Peer type it connects. Item Configuration The Configuration tab allows you to set parameters for the Wireless CompactFlash Card. - 14 - Item Description Saves values for all previous setting Profile parameters. The default values contain the parameters configured at Name installation. Once the demands for switching between different networking environments are met, you can set the additional profiles to reduce the configuration time. To save the current parameters, highlight the Profile field, type a new name, and click on the Apply button. A specific name shared among Network connected Wireless CompactFlash Name Card, Access Points and other wireless stations on the wireless network. The name must be identical for all devices and points attempting to connect to the same network. Network Access Point: allows the Adapter to Type communicate with a wired network which employing an Access Point. Peer-to-Peer: allows PC-to-PC, station-to-station communication without employing an Access Point. [. . . ] The default key field can be for specifying which of the encryption keys to transmit on the wireless network. used four data the Apply You must use the same value/phrase and WEP key settings for all wireless computers in order for the wireless network to function properly. - 17 - Site Survey The Site Survey tab shows all the available Access Points or Peer-to-Peer types and their features. Item Network Name BSSID Channel Network Type Description The name must be identical for all devices and points attempting to connect to the same network. A set of wireless stations is referred to as a Basic Service Set (BSS). Access Point: allows the Adapter to communicate with a wired network which employing an Access Point. [. . . ]