User manual HARTAN ZX II

[. . . ] For safety reasons, only use Hartan accessories and replacement parts. Transportation lock In order to be able to use the pram, you need to open the strap buckle 21. For transport, fold the pram; and remember to close the buckle to prevent it from unfolding. unfolding the pram By pushing the lock buttons 4 , unfold the upper section to bring the handle in horizontal position. [. . . ] Adjusting the backrest By lifting the back clip 13 at the rear, the backrest can be adjusted from sitting to reclining position in close steps. When adjusting the backrest, take care no movable parts jam the baby's limbs, or fingers, etc. As an additional protection preventing the baby from falling out of the carriage, secure the hood to the metal back. To do this, join the two hood grommets 17 to their respective turn-lock fasteners, and the hook locks 18 to the metal ring on the cross tube at the rear as well. Remember to tighten the seat belt when it slacks, which is done by means of the adjuster buckle. Adjusting the footrest By pressing the two red safety buttons 15 at the same time, the footrest can be lowered. In case the carrycot is attached to the frame, the footrest should always be in horizontal position, as an additional protection preventing it from slipping out. Sun canopy -- Silently adjustable hood Press the two front hood bows together 9 to adjust the hood. By taking off the rear hood section 10, the hood can be converted into a sun canopy by means of a zip fastener. Hood and safety bar By pressing the bayonet joint, the hood or the safety bar 12 can be pulled out. When inserting it, make sure the safety bar locks into place correctly and be careful not to pinch any of the fabric parts. Suitability for your child The ZX II twin stroller unit is designed to carry children from the age of 6 months, and up to 15kg in weight (total 30kg). The ZX II model is not suitable for children under the age of 6 months except in connection with an appropriate carrycot. Care of the fabric parts Clean soiled fabrics when dry using a clothes-brush or lukewarm water (then use hair dryer). all removable fabric parts may be machine washed in lukewarm water at a gentle setting and reduced agitation , at 30 °C. Dry your carriage with the hood still on in a dry and airy room using a cloth. This prevents marking as well as the underlining fabrics from moist soaking in through the seams. As a guaranteed protection against rain, we recommend that you use our rain cover, which is either included or can be purchased at your dealer's. That's why you should park your carriage in the shade whenever possible. You should clean and slightly lubricate the wheel axles at a regular 4-weeks interval. Use a silicone based lubricant spray for all moving plastic parts to maintain them in an operative condition. Keep all coated and chrome-plated metal parts in dry condition, and use a finish restorer or chrome paste if necessary. [. . . ] Tearing of seams, fabrics, press studs : At the time of purchase, please check carefully that all the fabric parts, seams and snap fasteners have properly been sewn and fastened. In case of a possible complaint concerning seams/defective snap fasteners, a claim must immediately be reported to your dealer after the defect has been discovered. Wheels: As wheels used on prams will not be balanced, they may show slight runouts ("wobbles"). No claim can be raised if your pram, using pneumatic tired wheels, has a "flat". [. . . ]