User manual HARTAN SKATER S

[. . . ] Shopping bags must not be hung on the handle as this may affect the stability of the pram. The carriage top, the seat unit, and the carrycot may not be used as a child car seat in vehicles. For safety reasons, only use Hartan accessories and replacement parts. Folding the pram Turn safety turn-lock 3 inward until the handle's catch 1 has released. [. . . ] When adjusting the backrest, take care no movable parts jam the baby's limbs, or fingers, etc. Remember to tighten the seat belt when it slacks, which is done by means of the adjuster buckles. For reasons of safety, pass the belt buckle through the shackle F when closing the safety belt. As an additional protection preventing babies from slipping out, pass the crotch belt D through the loop G on the seat. Adjusting the footrest First, press the two buttons 15, located at the right and left side respectively, to fold the footrest down. In case the carrycot is attached to the frame, the footrest should always be in horizontal position, as an additional protection preventing it from slipping out. Automatic lock for upper section 19 Place the carrycot or stroller unit upon the chassis in a way that the two lateral pins engage in the respective slots on each side. The catching pins on both sides engage automatically, which is indicated each time by a click sound. By pulling the upper section, check before use whether it is fixed securely!If the red safety point can still be seen, the upper-section lock has not yet completely closed!Pull the locking lever downwards until it snaps into place to open the lock and to remove the upper section. As an additional protection preventing the baby from falling out of the carriage, secure the hood to the metal back. To do this, join the two grommets 17 to their respective turn-lock fasteners, and the hook lock 18 to the metal ring on the back plate as well. Suitability for your child The Skater S stroller unit is designed to carry a child from the age of 6 months, and up to 15kg in weight. The Skater S stroller is not suitable for children under the age of 6 months except in connection with an appropriate carrycot. Care of the fabric parts Clean soiled fabrics when dry using a clothes-brush or lukewarm water (then use hair dryer). all removable fabric parts may be machine washed in lukewarm water at a gentle setting and reduced agitation , at 30 °C. Dry your carriage with the hood still on in a dry and airy room using a cloth. This prevents marking as well as the underlining fabrics from moist soaking in through the seams. As a guaranteed protection against rain, we recommend that you use our rain cover, which is either included or can be purchased at your dealer's. That's why you should park your carriage in the shade whenever possible. You should clean and slightly lubricate the wheel axles at a regular 4-weeks interval. [. . . ] It cannot be ruled out that colours of the fabrics may fade while the parts are exposed to direct sunlight, washed too frequently, come into contact with sweat and detergents, or suffer abrasive wear (especially on those parts where the pram is handled). It is unavoidable that colours sometimes differ slightly from one individual batch to the next, which is why this case will not be covered under the warranty. Knob formation on fabrics: We recommend that you apply general clothes care. As with woollen sweaters, the knobs can easily be removed by using a clothes-brush or burling machine. [. . . ]