User manual HARTAN RS ONE S

[. . . ] Shopping bags must not be hung on the handle as this may affect the stability of the pram. The carriage top, the seat unit, and the carrycot may not be used as a child car seat in vehicles. For safety reasons, only use Hartan accessories and replacement parts. Unfolding the pram By pushing the lock buttons 5, unfold the handle and bring its two sections in line. [. . . ] To remove the wheel, depress this button and pull the wheel off the holding device. To assemble the wheel, insert the fastening pin in the holding device, and engage it by a forcible push, which is indicated by a click sound. Adjustable suspension system By turning the selector 8, a "hard" or "soft" position can be selected for suspension. Automatic lock for upper section Place the stroller unit upon the chassis and pull it into the upper-section lock slots on each side 17 until the catching pins on both sides have engaged, which is indicated each time by a click sound. By pulling the upper section horizontally, check before use whether it is fixed correctly!To release the upper-section lock, push the locking cap (see the arrow) back and press the red securing button downwards until it has engaged. When the locking cap is in pushed back position and the red safety point can still be seen, the upper-section lock has not yet closed completely. Adjusting the footrest First, press the two buttons 15, located at the right and left side respectively, to fold the footrest down. In case the carrycot is attached to the frame, the footrest should always be in horizontal position, as an additional protection preventing it from slipping out. Adjusting the backrest By lifting the back clip 13 at the rear, the backrest can be adjusted from sitting to reclining position in close steps. When adjusting the backrest, take care that no movable parts jam the baby's limbs, or fingers, etc. Remember to tighten the seat belt when it slacks, which is done by means of the adjuster buckles. For reasons of safety, pass the belt buckle through the shackle F when closing the safety belt. As an additional protection preventing the baby from falling out of the carriage, secure the hood to the metal back. To do this, join the two hood grommets 18 to their respective turn-lock fasteners, and the back hooks 19 to the metal ring at the back plate as well. Suitability for your child The RS one S stroller unit is designed to carry a child from the age of 6 months, and up to 15kg in weight. The RS one S stroller is not suitable for children under the age of 6 months except in connection with an appropriate carrycot. Care of the fabric parts Clean soiled fabrics when dry using a clothes-brush or lukewarm water (then use hair dryer). all removable fabric parts may be machine washed in lukewarm water at a gentle setting and reduced agitation , at 30 °C. Dry your carriage with the hood still on in a dry and airy room using a cloth. This prevents marking as well as the underlining fabrics from moist soaking in through the seams. As a guaranteed protection against rain, we recommend that you use our rain cover, which is either included or can be purchased at your dealer's. [. . . ] bleaching of the fabrics: We confirm that the fabrics comply with the established standards. It cannot be ruled out that colours of the fabrics may fade while the parts are exposed to direct sunlight, washed too frequently, come into contact with sweat and detergents, or suffer abrasive wear (especially on those parts where the pram is handled). It is unavoidable that colours sometimes differ slightly from one individual batch to the next, which is why this case will not be covered under the warranty. Knob formation on fabrics: We recommend that you apply general clothes care. [. . . ]