User manual HARTAN RACER XL

[. . . ] Shopping bags must not be hung on the handle as this may affect the stability of the pram. The carriage top, the seat unit, and the carrycot may not be used as a child car seat in vehicles. For safety reasons, only use Hartan accessories and replacement parts. Folding the pram Turn safety turn-lock 3 inward until the handle's 1 catch has released. [. . . ] By taking off the rear hood section 11, the hood can be converted into a sun canopy by means of a zip fastener. Hood and safety bar By pressing the bayonet joint 12, the hood or the safety bar can be pulled out. When inserting it, make sure the safety bar locks into place correctly and be careful not to pinch any of the fabric parts. The hood bar 9 of the stroller and the safety bar are not suitable for carrying the pram. Adjusting the backrest By lifting the back clip 13 at the rear, the backrest can be adjusted from sitting to reclining position in close steps. When adjusting the backrest, take care no movable parts jam the baby's limbs, or fingers, etc. Remember to tighten the seat belt when it slacks, which is done by means of the adjuster buckles. For reasons of safety, pass the belt buckle through the shackle F when closing the safety belt. Adjusting the footrest First, press the two buttons 15, located at the right and left side respectively, to fold the footrest down. In case the carrycot is attached to the frame, the footrest should always be in horizontal position, as an additional protection preventing it from slipping out. This carrycot is suitable for holding only one baby, which cannot yet sit up on its own, or roll on its side or support itself on hands and knees. Be aware of the risks posed by open fires or other sources of heat, such as electric heaters, gas flames etc. Retractable mounting frame By means of a retractable mounting frame attached from the outside to the bottom of the carrycot 18, the height of the horizontal surface can be optimally adjusted. To take the carrycot along with you, fold the frame toward the bottom of the carrycot 18. As an additional protection preventing the baby from falling out of the carriage, secure the hood to the metal back. To do this, join the two grommets 19 to their respective turn-lock fasteners, and the hook lock 20 to the metal ring on the back plate as well. Suitability for your child The Racer and Racer S stroller units ('S' for 'swivel wheels') are designed to carry a child from the age of 6 months, and up to 15kg in weight. The Racer XL and Racer XLS carriage units ('S' for 'swivel wheels') are designed to carry a child from birth ­ up to the age of 12 months, and up to 9 kg in weight. Care of the fabric parts Clean soiled fabrics when dry using a clothes-brush or lukewarm water (then use hair dryer). all removable fabric parts may be machine washed in lukewarm water at a gentle setting and reduced agitation , at 30 °C. Dry your carriage with the hood still on in a dry and airy room using a cloth. This prevents marking as well as the underlining fabrics from moist soaking in through the seams. [. . . ] Mould formation: Fabric parts, having become wet, should be dried properly to prevent mould formation (see Instructions). bleaching of the fabrics: We confirm that the fabrics comply with the established standards. It cannot be ruled out that colours of the fabrics may fade while the parts are exposed to direct sunlight, washed too frequently, come into contact with sweat and detergents, or suffer abrasive wear (especially on those parts where the pram is handled). It is unavoidable that colours sometimes differ slightly from one individual batch to the next, which is why this case will not be covered under the warranty. [. . . ]